Nissan X-Trail 32. Instruction — part 2180
TM-678
< REMOVAL AND INSTALLATION >
[CVT: RE0F10G]
G SENSOR
G SENSOR
Exploded View
INFOID:0000000010623977
Removal and Installation
INFOID:0000000010623978
CAUTION:
• Never drop or strike G sensor, because it has little tolerance for impact.
• Never use a power tool to avoid impact.
REMOVAL
1.
Turn ignition switch OFF.
2.
Remove the center console assembly. Refer to
IP-25, "Removal and Installation"
(RHD models).
3.
Disconnect the G sensor harness connector
.
4.
Remove G sensor mounting nuts (
) and remove G sensor
.
INSTALLATION
Installation is the reverse order of removal.
G sensor
: Vehicle front
: N·m (kg-m, in-lb)
JSDIA5138GB
JSDIA5192ZZ
JSDIA5193ZZ
G SENSOR
TM-679
< REMOVAL AND INSTALLATION >
[CVT: RE0F10G]
C
E
F
G
H
I
J
K
L
M
A
B
TM
N
O
P
Adjustment
INFOID:0000000010623979
ADJUSTMENT AFTER INSTALLATION
Perform “CALIBRATION OF G SENSOR”. Refer to
TM-680
< REMOVAL AND INSTALLATION >
[CVT: RE0F10G]
AIR BREATHER
AIR BREATHER
Exploded View
INFOID:0000000010622882
Removal and Installation
INFOID:0000000010622883
REMOVAL
1.
Remove the air duct (inlet), air cleaner cases assembly with mass air flow sensor, and air duct assembly.
Refer to
EM-308, "Removal and Installation"
2.
Remove air breather hose.
INSTALLATION
Installation is in the reverse order of removal.
CAUTION:
• Never bend the air breather hose to prevent damage to the hose.
• Insert air breather hose to the end of air breather.
• Insert air breather hose
to air breather tube
all the way to
the curve of the tube.
• Insert air breather hose to air breather tube so that the paint
mark
is facing upward.
Air breather hose cap
Air breather hose
Breather tube
Transaxle assembly
JSDIA5220ZZ
JSDIA5387ZZ
OIL PAN
TM-681
< REMOVAL AND INSTALLATION >
[CVT: RE0F10G]
C
E
F
G
H
I
J
K
L
M
A
B
TM
N
O
P
OIL PAN
Exploded View
INFOID:0000000010622886
Removal and Installation
INFOID:0000000010622887
REMOVAL
1.
Remove the engine under cover. Refer to
EXT-40, "ENGINE UNDER COVER : Removal and Installation"
.
2.
Remove the drain plug
from oil pan and drain the CVT fluid.
Transaxle assembly
Oil pan gasket
Oil pan
Drain plug
Drain plug gasket
Magnet
Overflow plug
O-ring
: Always replace after every disassembly.
: N·m (kg-m, ft-lb)
: N·m (kg-m, in-lb)
: Apply CVT fluid
JSDIA4194GB
JSDIA5205ZZ
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст