Nissan X-Trail 32. Instruction — part 2004
STR-16
< WIRING DIAGRAM >
STARTING SYSTEM
JRBWC7646GB
STARTING SYSTEM
STR-17
< WIRING DIAGRAM >
C
D
E
F
G
H
I
J
K
L
M
A
STR
N
P
O
JRBWC7647GB
STR-18
< WIRING DIAGRAM >
STARTING SYSTEM
JRBWC7648GB
DIAGNOSIS AND REPAIR WORK FLOW
STR-19
< BASIC INSPECTION >
C
D
E
F
G
H
I
J
K
L
M
A
STR
N
P
O
BASIC INSPECTION
DIAGNOSIS AND REPAIR WORK FLOW
Work Flow
INFOID:0000000010957647
DETAILED FLOW
NOTE:
If any malfunction is found, immediately disconnect the battery cable from the negative terminal.
CAUTION:
For models with stop/start system, erase the starter operation counter when the starter motor is
replaced. Refer to
1.
CHECK ENGINE TYPE
Check the vehicle information.
>> GO TO 2.
2.
CHECK ENGINE START
Crank the engine and check that the engine starts.
Does the engine start?
YES
>> GO TO 3.
NO
>> GO TO 4.
3.
CHECK THAT THE STARTER MOTOR STOPS
Check that the starter motor stops after starting the engine.
Does the starter motor stop?
YES
>> INSPECTION END
NO-1
>> Type 1: Replace starter motor.
NO-2
>> Type 2: Replace magnetic switch.
4.
CHECK THE ENGINE SPEED WITH CRANKING
Check that the engine runs at cranking.
Does engine turn by cranking?
YES
>> GO TO 5.
NO
>> GO TO 6.
5.
CHECK THE ENGINE SPEED WITH CRANKING
Check that the engine speed is not low at cranking.
Does engine turn normally?
YES
>> Check ignition/fuel system.
NO
>> Check charge condition, corrosion and connection condition of the battery. Refer to
(R9M engine) or
PG-124, "EXCEPT FOR R9M : Work Procedure"
(Except for
R9M engine).
6.
CHECK STARTER MOTOR ACTIVATION
Check that the starter motor runs at cranking.
Does starter motor turn?
YES-1 >> Type 1: Replace starter motor.
YES-2 >> Type 2: GO TO 7.
NO
>> GO TO 8.
Type
Engine
1
R9M engine
2
QR engine
MR engine
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст