Nissan Teana J32. Instruction — part 134
AV
DVD PLAYER
AV-391
< ON-VEHICLE REPAIR >
[BOSE AUDIO WITHOUT NAVIGATION]
C
D
E
F
G
H
I
J
K
L
M
B
A
O
P
DVD PLAYER
Exploded View
INFOID:0000000003838353
REMOVAL
.
DISASSEMBLY
Removal and Installation
INFOID:0000000003838354
REMOVAL
1.
Remove grove box. Refer to
IP-12, "Removal and Installation"
2.
Remove DVD player mounting screw, disconnect the DVD player connector.
3.
Remove DVD player.
INSTALLATION
Installation is the reverse order of removal.
JPNIA1047ZZ
1.
DVD player
AV-392
< ON-VEHICLE REPAIR >
[BOSE AUDIO WITHOUT NAVIGATION]
AUXILIARY INPUT JACKS
AUXILIARY INPUT JACKS
Exploded View
INFOID:0000000003838355
REMOVAL
IP-22, "Removal and Installation"
DISASSEMBLY
Removal and Installation
INFOID:0000000003838356
REMOVAL
1.
Remove console finisher. Refer to
2.
Remove auxiliary mounting screws.
3.
Remove auxiliary input jacks.
INSTALLATION
Installation is the reverse order of removal.
JPNIA1048ZZ
1.
Auxiliary input jacks
AV
CAMERA CONTROL UNIT
AV-393
< ON-VEHICLE REPAIR >
[BOSE AUDIO WITHOUT NAVIGATION]
C
D
E
F
G
H
I
J
K
L
M
B
A
O
P
CAMERA CONTROL UNIT
Exploded View
INFOID:0000000003838365
Removal and Installation
INFOID:0000000003838366
REMOVAL
1.
Remove rear wheelhouse finisher RH. Refer to
INT-57, "Removal and Installation"
.
2.
Remove camera control unit mounting screws, disconnect the camera control unit connector.
3.
Remove camera control unit.
INSTALLATION
1.
Installation is the reverse order of removal.
2.
Perform predicted course line center position adjustment. Refer to
AV-187, "PREDICTED COURSE LINE
CENTER POSITION ADJUSTMENT : Special Repair Requirement"
JPNIA1049ZZ
1.
Camera control unit
AV-394
< ON-VEHICLE REPAIR >
[BOSE AUDIO WITHOUT NAVIGATION]
REAR VIEW CAMERA
REAR VIEW CAMERA
Exploded View
INFOID:0000000003902723
DISASSEMBLY
Removal and Installation
INFOID:0000000003902724
REMOVAL
1.
Remove trunk lid finisher inner. Refer to
INT-59, "Removal and Installation"
2.
Remove trunk lid finisher. Refer to
EXT-38, "Removal and Installation"
3.
Remove rear view camera mounting clip, disconnect the rear view camera connector.
4.
Remove rear view camera.
INSTALLATION
1.
Installation is the reverse order of removal.
Adjustment
INFOID:0000000003970795
Adjust the guide line position if the guide line position is shifted after installing the rear view camera.
1.
Draw lines on rearward area of the vehicle passing through the
following points: 200 mm (7.87 in) from both sides of the vehicle,
and 0.5 m (1.64 ft), 1.0 m (3.28 ft) from the rear end of the
bumper.
2.
Set into “Adjust offset of rear view camera” mode of Confirma-
tion / Adjustment mode.
JPNIA1050ZZ
1.
Rear view camera
2.
Seal
for symbols in the figure.
SKIB3691E
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст