Nissan Teana J32. Instruction — part 362
TRUNK LID LOCK
DLK-231
< ON-VEHICLE REPAIR >
[WITH INTELLIGENT KEY SYSTEM]
C
D
E
F
G
H
I
J
L
M
A
B
DLK
N
O
P
TRUNK LID LOCK
Exploded View
INFOID:0000000003819768
Removal and Installation
INFOID:0000000003813439
REMOVAL
1.
Remove trunk lid finisher inner. Refer to
INT-59, "Removal and Installation"
2.
Disconnect trunk lid opener cable.
3.
Disconnect trunk lid lock assembly and trunk lid opener switch connectors.
4.
Remove mounting bolts and remove trunk lid lock assembly.
INSTALLATION
Install in the reverse order of removal.
CAUTION:
Check trunk lid open/close, lock/unlock operation after installation.
1.
Trunk lid
2.
Trunk lid weather-strip
3.
Cap
4.
Stopper
5.
Trunk lid hinge
6.
Trunk lid striker
7.
Bumper rubber
8.
Trunk lid lock assembly
9.
Trunk lid stay
A
: Center mark (upper)
B.
: Center mark (lower)
Refer to
for symbols in the figure.
JMKIA2389GB
DLK-232
< ON-VEHICLE REPAIR >
[WITH INTELLIGENT KEY SYSTEM]
FUEL FILLER LID OPENER
FUEL FILLER LID OPENER
Exploded View
INFOID:0000000003813440
Removal and Installation
INFOID:0000000003813441
NOTE:
When fuel filler lid opener actuator (1) is malfunctioning, pull the rod
to open fuel filler lid.
REMOVAL
1.
Remove mounting screws, and then remove fuel filler lid.
2.
Rotate lock nut counterclockwise, and then remove lock nut.
3.
Push fuel filler lid opener actuator behind the vehicle, while pushing the pawl.
4.
Remove rear wheel house finisher (LH). Refer to
INT-57, "Removal and Installation"
5.
Disconnect harness connector and remove fuel filler lid opener actuator.
INSTALLATION
Install in the reverse order of removal.
CAUTION:
1.
Fuel filler lid assembly
2.
Bumper rubber
3.
Lock nut
4.
Fuel filler lid opener actuator
JMKIA2390ZZ
JMKIA1960ZZ
FUEL FILLER LID OPENER
DLK-233
< ON-VEHICLE REPAIR >
[WITH INTELLIGENT KEY SYSTEM]
C
D
E
F
G
H
I
J
L
M
A
B
DLK
N
O
P
After installation, apply the touch-up paint (the body color) onto the head of the mounting screws.
DLK-234
< ON-VEHICLE REPAIR >
[WITH INTELLIGENT KEY SYSTEM]
DOOR SWITCH
DOOR SWITCH
Exploded View
INFOID:0000000003795126
Removal and Installation
INFOID:0000000003795127
REMOVAL
1.
Remove the door switch trox bolt (A), and then remove door
switch (1).
INSTALLATION
Install in the reverse order of removal.
1.
Door switch
2.
Trox bolt
JMKIA2569GB
JMKIA2173ZZ
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст