Nissan Teana J32. Instruction — part 279
CHG
CHARGING SYSTEM
CHG-17
< SYMPTOM DIAGNOSIS >
C
D
E
F
G
H
I
J
K
L
B
A
O
P
N
SYMPTOM DIAGNOSIS
CHARGING SYSTEM
Symptom Table
INFOID:0000000003860530
Symptom
Reference
Discharged battery
Refer to
.
The charge warning lamp does not illuminate when the ignition
switch is set to ON.
The charge warning lamp does not turn OFF after the engine
starts.
The charge warning lamp turns ON when increasing the engine
speed.
CHG-18
< PRECAUTION >
PRECAUTIONS
PRECAUTION
PRECAUTIONS
Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT
PRE-TENSIONER"
INFOID:0000000003860531
The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-TENSIONER”, used along
with a front seat belt, helps to reduce the risk or severity of injury to the driver and front passenger for certain
types of collision. Information necessary to service the system safely is included in the “SRS AIRBAG” and
“SEAT BELT” of this Service Instruction.
WARNING:
• To avoid rendering the SRS inoperative, which could increase the risk of personal injury or death in
the event of a collision which would result in air bag inflation, all maintenance must be performed by
an authorized NISSAN/INFINITI dealer.
• Improper maintenance, including incorrect removal and installation of the SRS, can lead to personal
injury caused by unintentional activation of the system. For removal of Spiral Cable and Air Bag
Module, see the “SRS AIRBAG”.
• Never use electrical test equipment on any circuit related to the SRS unless instructed to in this Ser-
vice Instruction. SRS wiring harnesses can be identified by yellow and/or orange harnesses or harness
connectors.
CHG
PREPARATION
CHG-19
< PREPARATION >
C
D
E
F
G
H
I
J
K
L
B
A
O
P
N
PREPARATION
PREPARATION
Special Service Tools
INFOID:0000000003860532
Tool number
Tool name
Description
KV10118200 (included in the adapter
kit: Mot. 1732)
Alternator pulley adapter
Removing and installing alternator pulley
PKIA1241E
CHG-20
< ON-VEHICLE MAINTENANCE >
CHARGING SYSTEM PRELIMINARY INSPECTION
ON-VEHICLE MAINTENANCE
CHARGING SYSTEM PRELIMINARY INSPECTION
Inspection Procedure
INFOID:0000000003860533
1.
CHECK BATTERY TERMINALS CONNECTION
Check if battery terminals are clean and tight.
Is the inspection result normal?
YES
>> GO TO 2.
NO
>> Repair battery terminals connection.
2.
CHECK FUSE
Check for blown fuse.
Is the inspection result normal?
YES
>> GO TO 3.
NO
>> Be sure to eliminate the cause of malfunction before installing new fuse.
3.
CHECK “E” TERMINAL CONNECTION
Check if “E” terminal (alternator ground harness) is clean and tight.
Is the inspection result normal?
YES
>> GO TO 4.
NO
>> Repair “E” terminal connection.
4.
CHECK DRIVE BELT TENSION
Check drive belt tension. Refer to the following
Is the inspection result normal?
YES
>> INSPECTION END
NO
>> Repair as needed.
Unit
Power source (Power supply terminals)
Fuse No.
Alternator
Battery (“S” terminal)
36
Combination meter
Ignition switch ON (“L” terminal)
4
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст