Nissan Teana J32. Instruction — part 654
HA-44
< ON-VEHICLE REPAIR >
HIGH-PRESSURE PIPE
HIGH-PRESSURE PIPE
Exploded View
INFOID:0000000003839912
HA-14, "Refrigerant Connection"
.
Removal and Installation
INFOID:0000000003839913
REMOVAL
1.
Remove low-pressure pipe. Refer to
2.
Disconnect high-pressure pipe (1) from expansion valve.
CAUTION:
Cap or wrap the joint of the A/C piping and expansion valve
with suitable material such as vinyl tape to avoid the entry
of air.
1.
High-pressure pipe
2.
O-ring
3.
Condenser
4.
High-pressure flexible hose
5.
Compressor
6.
Low-pressure flexible hose
7.
Low-pressure pipe
8.
Heater & cooling unit assembly
9.
Blower unit
10. Evaporator pipe assembly
11.
Expansion valve
12. Evaporator
Refer to
for symbols in the figure.
JPIIA0952GB
JPIIA0972ZZ
HIGH-PRESSURE PIPE
HA-45
< ON-VEHICLE REPAIR >
C
D
E
F
G
H
J
K
L
M
A
B
HA
N
O
P
3.
Remove mounting bolt (A), and then disconnect high-pressure
flexible hose (1) and high-pressure pipe (2) from condenser pipe
assembly.
CAUTION:
Cap or wrap the joint of the A/C piping with suitable mate-
rial such as vinyl tape to avoid the entry of air.
4.
Remove reservoir tank. refer to
.
5.
Remove mounting clips (A), and then remove high-pressure pipe (1).
INSTALLATION
Installation is basically the reverse order of removal.
CAUTION:
• Replace O-rings with new ones. Then apply compressor oil to them when installing.
• Check for leakages when recharging refrigerant.
JPIIA0979ZZ
JPIIA0974ZZ
HA-46
< ON-VEHICLE REPAIR >
CONDENSER
CONDENSER
Exploded View
INFOID:0000000003795846
Removal and Installation
INFOID:0000000003839914
REMOVAL
1.
Remove condenser pipe assembly. Refer to
2.
Remove mounting clip (A).
3.
Disconnect hood lock cable (1), and then move hood lock pro-
tector (2) to a position where it does not inhibit work.
4.
Disconnect refrigerant pressure sensor connector (A).
1.
Condenser pipe assembly
2.
O-ring
3.
Condenser
4.
Condenser lower bracket LH
5.
Bracket
6.
Liquid tank
7.
Refrigerant pressure sensor
8.
Liquid tank bracket
9.
Condenser upper bracket LH
10. Condenser upper bracket RH
Refer to
for symbols in the figure.
JPIIA0978GB
JPIIA0981ZZ
JPIIA0982ZZ
CONDENSER
HA-47
< ON-VEHICLE REPAIR >
C
D
E
F
G
H
J
K
L
M
A
B
HA
N
O
P
5.
Disengage tabs (A).
6.
Pull condenser (1) upward of vehicle, and then remove con-
denser (as shown in the figure).
CAUTION:
Be careful not to damage core surface of condenser.
INSTALLATION
Installation is basically the reverse order of removal.
CAUTION:
• Replace O-rings with new ones. Then apply compressor oil to them when installing.
• Check for leakages when recharging refrigerant.
JPIIA0983ZZ
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст