Nissan Teana J32. Instruction — part 203
AV
TEL ANTENNA
AV-667
< ON-VEHICLE REPAIR >
[BOSE AUDIO WITH NAVIGATION]
C
D
E
F
G
H
I
J
K
L
M
B
A
O
P
TEL ANTENNA
Harness Layout
INFOID:0000000003766014
JPNIA1054GB
AV-668
< ON-VEHICLE REPAIR >
[BOSE AUDIO WITH NAVIGATION]
TEL ANTENNA
Exploded View
INFOID:0000000003766015
Removal and Installation
INFOID:0000000003766016
REMOVAL
1.
Remove rear parcel shelf finisher. Refer to
INT-43, "Removal and Installation"
2.
Remove trunk front finisher. Refer to
INT-57, "Removal and Installation"
3.
Remove TEL antenna mounting nit, disconnect the TEL antenna connector.
4.
Remove TEL antenna.
INSTALLATION
Install in the reverse order of removal.
JPNIA1053ZZ
1.
TEL antenna
AV
CAMERA CONTROL UNIT
AV-669
< ON-VEHICLE REPAIR >
[BOSE AUDIO WITH NAVIGATION]
C
D
E
F
G
H
I
J
K
L
M
B
A
O
P
CAMERA CONTROL UNIT
Exploded View
INFOID:0000000003766017
Removal and Installation
INFOID:0000000003766018
REMOVAL
1.
Remove rear wheelhouse finisher RH. Refer to
INT-57, "Removal and Installation"
.
2.
Remove camera control unit mounting screws, disconnect the camera control unit connector.
3.
Remove camera control unit.
INSTALLATION
1.
Installation is the reverse order of removal.
2.
Perform predicted course line center position adjustment. Refer to
AV-400, "PREDICTED COURSE LINE
CENTER POSITION ADJUSTMENT : Special Repair Requirement"
JPNIA1049ZZ
1.
Camera control unit
AV-670
< ON-VEHICLE REPAIR >
[BOSE AUDIO WITH NAVIGATION]
REAR VIEW CAMERA
REAR VIEW CAMERA
Exploded View
INFOID:0000000003766021
DISASSEMBLY
Removal and Installation
INFOID:0000000003766022
REMOVAL
1.
Remove trunk lid finisher inner. Refer to
INT-59, "Removal and Installation"
2.
Remove trunk lid finisher. Refer to
EXT-38, "Removal and Installation"
3.
Remove rear view camera mounting clip, disconnect the rear view camera connector.
4.
Remove rear view camera.
INSTALLATION
1.
Installation is the reverse order of removal.
Adjustment
INFOID:0000000003901754
Adjust the guide line position if the guide line position is shifted after installing the rear view camera.
1.
Draw lines on rearward area of the vehicle passing through the
following points: 200 mm (7.87 in) from both sides of the vehicle,
and 0.5 m (1.64 ft), 1.0 m (3.28 ft) from the rear end of the
bumper.
2.
Set into “Adjust offset of rear view camera” mode of Confirma-
tion / Adjustment mode.
JPNIA1050ZZ
1.
Rear view camera
2.
Seal
for symbols in the figure.
SKIB3691E
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст