Nissan Leaf. Instruction — part 1151
TM-10
< PREPARATION >
[REDUCTION GEAR: RE1F61B]
PREPARATION
Insulated helmet
Removing and installing high voltage com-
ponents
Insulation resistance tester
(Multi tester)
Measuring insulation resistance, voltage,
and resistance
Tool name
Description
JPCIA0013ZZ
JPCIA0014ZZ
STRUCTURE AND OPERATION
TM-11
< SYSTEM DESCRIPTION >
[REDUCTION GEAR: RE1F61B]
C
E
F
G
H
I
J
K
L
M
A
B
TM
N
O
P
SYSTEM DESCRIPTION
STRUCTURE AND OPERATION
Sectional View
INFOID:0000000010119521
Input gear
Brush cover
Earth brush
O-ring
Final gear
Main shaft
JSDIA3977ZZ
TM-12
< SYSTEM DESCRIPTION >
[REDUCTION GEAR: RE1F61B]
STRUCTURE AND OPERATION
Power Transfer Diagram
INFOID:0000000010119522
From traction motor
To drive shaft
: Vehicle front
: Power flow
JSDIA3980ZZ
REDUCTION GEAR OIL
TM-13
< PERIODIC MAINTENANCE >
[REDUCTION GEAR: RE1F61B]
C
E
F
G
H
I
J
K
L
M
A
B
TM
N
O
P
PERIODIC MAINTENANCE
REDUCTION GEAR OIL
Inspection
INFOID:0000000010119523
OIL LEAKAGE
Check reduction gear surrounding area (oil seal, drain plug, and filler plug etc.) for oil leakage.
OIL LEVEL
• Remove filler plug and gasket. Then check that oil is filled up
from mounting hole for the filler plug.
CAUTION:
Turn the power switch OFF while checking oil level.
• Set a gasket on filler plug and install it on reduction gear and
tighten to the specified torque. Refer to
CAUTION:
• Never reuse gasket.
• If foreign matter, such as gear abrasion powder, is on the
magnet of the filler plug, wipe it free of adherents before
installation.
Draining and Refilling
INFOID:0000000010119524
DRAINING
1. Turn the power switch OFF.
2. Remove filler plug.
3. Remove drain plug and drain gear oil.
4. Set a gasket on drain plug and install it to reduction gear and
tighten to the specified torque. Refer to
CAUTION:
• Never reuse gasket.
• If foreign matter, such as gear abrasion powder, is on the
magnet of the drain plug, wipe it free of adherents before
installation.
REFILLING
1. Remove filler plug . Fill with new gear oil until oil level reaches
the specified level near filler plug mounting hole.
2. After refilling oil, check oil level. Set a gasket on filler plug, then
install it to reduction gear. Refer to
.
CAUTION:
• Never reuse gasket.
• If foreign matter, such as gear abrasion powder, is on the magnet of the filler plug, wipe it free of
adherents before installation.
JSDIA3975ZZ
JSDIA3976ZZ
Oil grade
: Refer to
CANADA : Fluids and Lubricants"
(USA and Canada) and
MEXICO : Fluids and Lubricants"
(Mexico).
Oil capacity
: Refer to
JSDIA3975ZZ
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст