Nissan Leaf. Instruction — part 797
SUNLOAD SENSOR
HAC-191
< REMOVAL AND INSTALLATION >
[AUTO A/C (WITH HEAT PUMP)]
C
D
E
F
G
H
J
K
L
M
A
B
HAC
N
O
P
SUNLOAD SENSOR
Removal and Installation
INFOID:0000000010121896
REMOVAL
1. Remove switch panel. Refer to
IP-17, "Removal and Installation"
2. Disconnect sunload sensor connector (A).
3. Disengage pawls, and then remove sunload sensor (1) from
switch panel.
INSTALLATION
Install in the reverse order of removal.
: Pawl
JPIIA1831ZZ
HAC-192
< REMOVAL AND INSTALLATION >
[AUTO A/C (WITH HEAT PUMP)]
INTAKE SENSOR
INTAKE SENSOR
Exploded View
INFOID:0000000010121897
1.
Blower motor
2.
Blower case RH
3.
Blower case LH
4.
High voltage warning label
5.
PTC heater shield RH
6.
PTC heater
7.
Heating and cooling unit assembly
case RH
8.
Case packing
9.
Evaporator
10. Plate
11. O-rings
12. Grommet
13. Low pressure pipe flange
14. Intake sensor
15. PTC heater shield lower
JMIIA2600GB
INTAKE SENSOR
HAC-193
< REMOVAL AND INSTALLATION >
[AUTO A/C (WITH HEAT PUMP)]
C
D
E
F
G
H
J
K
L
M
A
B
HAC
N
O
P
Removal and Installation
INFOID:0000000010121898
REMOVAL
1. Remove evaporator assembly. Refer to
HA-60, "EVAPORATOR : Removal and Installation"
2. Remove intake sensor from evaporator.
INSTALLATION
Note the following items, and then install in the order of removal.
CAUTION:
• Mark the mounting position of intake sensor bracket prior to removal so that the reinstalled sensor
can be located in the same position.
• When removing or installing the intake sensor, be sure not to rotate the bracket insertion part. Fail-
ure to do this may cause damage to the evaporator.
16. Evaporator cover
17. Inner condenser pipe cover
18. PTC heater shield LH
19. Inner condenser cover
20. Sleeve
21. Clip
22. Compressor discharge refrigerant
temperature sensor
23. Grommet
24. Gasket
25. Inner condenser
26. PTC heater outlet and A/C unit
case air temperature sensor as-
sembly
27. Heating and cooling unit
assembly case LH
28. Filter cover
29. Filter
30. Aspirator
31. Aspirator hose
32. Harness
33. PTC heater shield
34. Lower air mix door
35. Upper air mix door
36. Air mix door guide
37. Front door rod
38. Side ventilator door
39. Foot door
40. Side ventilator seal LH
41. Lower attachment case
42. Side ventilator seal RH
43. Center ventilator and defroster door 44. Sub defroster door
45. Upper attachment case
46. Defroster seal
47. Ventilator seal
48. Intake seal
49. Lower intake case
50. Intake door
51. Upper intake seal
52. Power transistor
53. Sub harness
: Always replace after every disassembly.
: N·m (kg-m, in-lb)
HAC-194
< REMOVAL AND INSTALLATION >
[AUTO A/C (WITH HEAT PUMP)]
COMPRESSOR DISCHARGE REFRIGERANT TEMPERATURE SENSOR
COMPRESSOR DISCHARGE REFRIGERANT TEMPERATURE SENSOR
Exploded View
INFOID:0000000010121899
1.
Blower motor
2.
Blower case RH
3.
Blower case LH
4.
High voltage warning label
5.
PTC heater shield RH
6.
PTC heater
7.
Heating and cooling unit assembly
case RH
8.
Case packing
9.
Evaporator
10. Plate
11. O-rings
12. Grommet
13. Low pressure pipe flange
14. Intake sensor
15. PTC heater shield lower
JMIIA2600GB
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст