Nissan Leaf. Instruction — part 1244
CHARGE CONNECTOR LOCK ACTUATOR
VC-143
< REMOVAL AND INSTALLATION >
D
E
F
G
H
I
J
K
L
M
A
B
VC
N
O
P
• Refer to
VC-6, "High Voltage Precautions"
CAUTION:
Never bring the vehicle into the READY status with the service plug removed unless otherwise
instructed in the Instruction. A malfunction may occur if this is not observed.
REMOVAL
WARNING:
Disconnect high voltage. Refer to
GI-33, "How to Disconnect High Voltage"
1. Check voltage in high voltage circuit. (Check that condenser are discharged.)
a. Lift up the vehicle and remove the Li-ion battery under covers. Refer to
b. Remove high voltage harness from clamp .
c. Disconnect high voltage harness connector and high voltage harness for PTC heater from front side of Li-
ion battery. Refer to
EVB-181, "Removal and Installation"
.
d. Measure voltage between high voltage harness connector terminals and high voltage harness connector
terminals for PTC heater.
DANGER:
Touching high voltage components without using the appropriate protective equipment will
cause electrocution.
CAUTION:
For voltage measurements, use a tester which can measure to 500 V or higher.
2. Remove the radiator upper grille. Refer to
DLK-165, "RADIATOR UPPER GRILLE : Removal and Installa-
JPCIA0299ZZ
Standard
: 5 V or less
JPCIA0296ZZ
VC-144
< REMOVAL AND INSTALLATION >
CHARGE CONNECTOR LOCK ACTUATOR
3. Disconnect the charge connector lock actuator harness connector .
4. Remove the normal charging port mounting nuts.
5. Remove the charge connector lock actuator.
INSTALLATION
Install in the reverse order of removal.
WARNING:
Be sure to put on insulating protective gear before beginning work on the high voltage system.
CAUTION:
Be sure to reinstall high-voltage harness clips in their original positions. If a clip is damaged, replace it
with a new clip before installing.
ALCIA0118ZZ
IMMEDIATE CHARGING SWITCH
VC-145
< REMOVAL AND INSTALLATION >
D
E
F
G
H
I
J
K
L
M
A
B
VC
N
O
P
IMMEDIATE CHARGING SWITCH
Removal and Installation
INFOID:0000000010121304
REMOVAL
1. Remove instrument lower panel LH. Refer to
2. Remove switch panel assembly from instrument lower panel LH.
3. Remove immediate charging switch from switch panel using a
suitable tool (A).
INSTALLATION
Install in the reverse order of removal.
JPCIA0378ZZ
VC-146
< REMOVAL AND INSTALLATION >
CHARGE CONNECTOR LOCK SWITCH
CHARGE CONNECTOR LOCK SWITCH
Removal and Installation
INFOID:0000000010121305
REMOVAL
1. Remove instrument lower panel LH. Refer to
2. Remove switch panel assembly from instrument lower panel LH.
3. Remove charge connector lock switch from switch panel
using a suitable tool (A).
INSTALLATION
Install in the reverse order of removal.
JPCIA0331ZZ
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст