Nissan Leaf. Instruction — part 883
INSTRUMENT PANEL ASSEMBLY
IP-27
< REMOVAL AND INSTALLATION >
C
D
E
F
G
H
I
K
L
M
A
B
IP
N
O
P
• Do not use the steering wheel nut after removal, replace with a new nut.
• Do not use the driver air bag module bolts after removal, replace with new bolts.
• Do not use the passenger air bag module bolt after removal, replace with a new bolt.
IP-28
< REMOVAL AND INSTALLATION >
CENTER CONSOLE ASSEMBLY
CENTER CONSOLE ASSEMBLY
Exploded View
INFOID:0000000010120162
Removal and Installation
INFOID:0000000010120163
CAUTION:
To prevent damage to the parts, when removing, always use a suitable tool that is made of plastic.
REMOVAL
1.
Console finisher assembly
2.
Instrument lower cover RH
3.
Heated seat switch RH
4.
Auxiliary input jack (if equipped)
5.
USB connector
6.
Heated seat switch LH
7.
Instrument lower center cover
8.
Instrument lower cover LH
9.
Center console assembly
10. Shift selector
11. Console rear finisher
12. Console lid assembly
13. Parking brake switch
14. Selector indicator
15. Console mask
Pawl
Metal clip
AWJIA1334ZZ
CENTER CONSOLE ASSEMBLY
IP-29
< REMOVAL AND INSTALLATION >
C
D
E
F
G
H
I
K
L
M
A
B
IP
N
O
P
1. Remove instrument lower center cover.
1. Apply protective tape (A) to console finisher assembly to
protect from damage.
2. Apply protective tape (A) around the part to protect from
damage.
3. Insert suitable tool (A) between instrument lower center
cover and center console assembly to disengage the metal
clips as shown.
4. Lift up instrument lower center cover, then disconnect harness connectors.
CAUTION:
Be careful not to scratch console finisher assembly with pawl or metal clip of instrument lower
center cover.
2. Remove instrument lower cover LH.
1. Remove clip (A).
2. Pull the instrument lower cover LH crosswise, and disen-
gage the pawls.
CAUTION:
Release pawls slowly so that they are not damaged.
JMJIA6095ZZ
JMJIA6989ZZ
: Metal clip
AWJIA1333ZZ
: Pawl
JMJIA5003ZZ
IP-30
< REMOVAL AND INSTALLATION >
CENTER CONSOLE ASSEMBLY
3. Remove center console assembly screw (A).
4. Remove instrument lower cover RH.
1. Remove clip (A).
2. Pull the instrument lower cover RH crosswise, and disen-
gage the pawls.
CAUTION:
Release pawls slowly so that they are not damaged.
5. Remove center console assembly screw (A).
6. Remove console finisher assembly.
1. Lift up console finisher assembly back side, then disengage
the pawls and metal clips according to the numerical order 1
→ 6 as shown.
2. Disconnect harness connectors.
CAUTION:
• Apply protective tape (B) around the part to protect from
damage.
• Disengage slowly so that pawls in rear end of console fin-
isher assembly are not damaged.
: Vehicle front
JMJIA5027ZZ
: Pawl
JMJIA5004ZZ
: Vehicle front
JMJIA5026ZZ
: Pawl
: Metal clip
JMJIA6100ZZ
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст