Nissan Leaf. Instruction — part 20
AV
REAR DOOR SPEAKER
AV-71
< REMOVAL AND INSTALLATION >
[AUDIO W/O NAVI (EXCEPT MEXICO)]
C
D
E
F
G
H
I
J
K
L
M
B
A
O
P
REAR DOOR SPEAKER
Removal and Installation
INFOID:0000000010122491
REMOVAL
1. Remove the rear door finisher. Refer to
INT-22, "Removal and Installation"
.
2. Remove the screws and disconnect the connector to remove the rear door speaker.
INSTALLATION
Install in the reverse order of removal.
AV-72
< REMOVAL AND INSTALLATION >
[AUDIO W/O NAVI (EXCEPT MEXICO)]
MICROPHONE
MICROPHONE
Removal and Installation
INFOID:0000000010122492
REMOVAL
1. Remove the map lamp assembly. Refer to
INL-52, "Removal and Installation"
.
2. Press the pawl to remove the microphone (1) from the map lamp
assembly.
CAUTION:
Use care when handling the microphone pawl to avoid dam-
aging.
INSTALLATION
Install in the reverse order of removal.
NOTE:
Check the microphone for looseness after the installation.
JPNIA1399ZZ
AV
BLUETOOTH CONTROL UNIT
AV-73
< REMOVAL AND INSTALLATION >
[AUDIO W/O NAVI (EXCEPT MEXICO)]
C
D
E
F
G
H
I
J
K
L
M
B
A
O
P
BLUETOOTH CONTROL UNIT
Removal and Installation
INFOID:0000000010122493
REMOVAL
1. Remove the luggage side lower finisher (RH). Refer to
INT-43, "LUGGAGE SIDE LOWER FINISHER :
.
2. Remove the four Bluetooth control unit nuts (A).
3. Disconnect the harness connectors from the Bluetooth control unit and remove.
4. Remove the Bluetooth control unit bracket screws and the
brackets (1, 3) from the Bluetooth control unit (2).
INSTALLATION
Install in the reverse order of removal.
ALNIA1510ZZ
ALNIA1511ZZ
AV-74
< REMOVAL AND INSTALLATION >
[AUDIO W/O NAVI (EXCEPT MEXICO)]
ANTENNA BASE
ANTENNA BASE
Removal and Installation
INFOID:0000000010122494
REMOVAL
1. Partially remove the headlining (rear side) to obtain space to work between vehicle and headlining. Refer
INT-37, "Removal and Installation"
.
2. Disconnect the antenna feeder connector.
3. Remove the nut and the antenna base (2) from the vehicle.
(1): Antenna rod
INSTALLATION
Install in the reverse order of removal.
CAUTION:
• Do not bend headlining when pulling down.
• Tighten the antenna base nut to specification.
- If the antenna base nut is less than the specified torque, it could affect the performance of the
antenna sensitivity.
- If the antenna base nut is greater than the specified torque, it could damage the roof panel.
JSNIA3850GB
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст