Nissan Frontier D40. Instruction — part 222
KEYFOB BATTERY AND FUNCTION
DLK-51
< COMPONENT DIAGNOSIS >
C
D
E
F
G
H
I
J
L
M
A
B
DLK
N
O
P
KEYFOB BATTERY AND FUNCTION
Description
INFOID:0000000005274533
The following functions are available when having and carrying electronic ID.
• Door lock/unlock
• Panic alarm
Remote control entry function and panic alarm function are available when operating the remote buttons.
Component Function Check
INFOID:0000000005274534
1.
CHECK FUNCTION
With CONSULT-III
Check remote keyless entry receiver "RKE OPE COUN1" in DATA MONITOR mode with CONSULT-III.
Is the inspection result normal?
YES
>> Key fob is OK.
NO
>> Refer to
.
Diagnosis Procedure
INFOID:0000000005274535
1.
CHECK KEYFOB FUNCTION
Check keyfob function using Remote Keyless Entry Tester J-43241.
Does the test pass?
YES
>> Key fob is OK.
NO
>> GO TO 2
2.
CHECK KEY FOB COMPONENTS
1.
Open the lid using a coin.
CAUTION:
• Do not touch the circuit board or battery terminal.
• The keyfob is water-resistant. However, if it does get wet,
immediately wipe it dry.
2.
Remove the key fob battery.
CAUTION:
• Keep dirt, grease, and other foreign materials off the elec-
trode contact area.
3.
Visually inspect keyfob internal components.
Is the inspection result normal?
YES
>> GO TO 3
NO
>> Repair or replace malfunctioning parts.
3.
CHECK KEY FOB BATTERY
Monitor item
Condition
RKE OPE COUN1
Check that the numerical value is changing while operating the key fob.
LEL946A
ALKIA1720GB
DLK-52
< COMPONENT DIAGNOSIS >
KEYFOB BATTERY AND FUNCTION
Check by connecting a resistance (approximately 300
Ω
) so that the
current value becomes about 10 mA.
Is the measurement value within specification?
YES
>> Key fob battery is OK. Check remote keyless entry
receiver. Refer to
.
NO
>> GO TO 4.
4.
REPLACE KEY FOB BATTERY
1.
Replace the key fob battery, positive side down.
2.
Align the tips of the upper and lower parts, and then push them
together until it is securely closed.
CAUTION:
• When replacing battery, keep dirt, grease, and other for-
eign materials off the electrode contact area.
3.
After replacing the battery, check that all key fob functions work
properly.
Is the inspection result normal?
YES
>> Key fob is OK.
NO
>> Check remote keyless entry receiver. Refer to
.
Standard
: Approx. 2.5 - 3.0V
OCC0607D
ALKIA1721GB
HORN FUNCTION
DLK-53
< COMPONENT DIAGNOSIS >
C
D
E
F
G
H
I
J
L
M
A
B
DLK
N
O
P
HORN FUNCTION
Description
INFOID:0000000005274536
Perform answer-back for each operation with horn.
Component Function Check
INFOID:0000000005274537
1.
CHECK FUNCTION
1.
Select "HORN" in “ACTIVE TEST” mode with CONSULT-III.
2.
Check the horn (high/low) operation.
Is the operation normal?
YES
>> Inspection End.
NO
>> Refer to
Diagnosis Procedure
INFOID:0000000005274538
Regarding Wiring Diagram information, refer to
DLK-94, "Wiring Diagram—REMOTE KEYLESS ENTRY SYS-
DLK-104, "Wiring Diagram—REMOTE KEYLESS ENTRY SYSTEM (Crew Cab)—"
.
1.
CHECK HORN FUNCTION
Check horn function with horn switch
Do the horns sound?
YES
>> GO TO 2
NO
>> Refer to
.
2.
CHECK HORN RELAY POWER SUPPLY
1.
Turn ignition switch ON.
2.
Perform “ACTIVE TEST”, "HORN" with CONSULT-Ill.
3.
Using an oscilloscope or analog voltmeter, check voltage
between IPDM E/R connector E122 terminal 45 and ground.
Is the inspection result normal?
YES
>> Repair or replace open harness between IPDM E/R and horn relay.
NO
>> GO TO 3
3.
CHECK HORN RELAY CIRCUIT
Test item
Description
HORN
ON
Horn relay
ON (for 20 ms)
WIIA1251E
IPDM E/R
Ground
Test item
Voltage (V)
(Approx.)
Connector
Terminal
E122
45
Ground
HORN
OFF
→
ON
→
OFF
Battery voltage
→
0
→
Battery voltage
Other than above
Battery voltage
DLK-54
< COMPONENT DIAGNOSIS >
HORN FUNCTION
1.
Turn ignition switch OFF.
2.
Disconnect IPDM E/R and horn relay connector.
3.
Check continuity between IPDM E/R harness connector and
horn relay harness connector.
4.
Check continuity between IPDM E/R harness connector and ground.
Is the inspection result normal?
YES
>> GO TO 4
NO
>> Repair or replace harness.
4.
CHECK INTERMITTENT INCIDENT
GI-46, "Intermittent Incident"
Is the inspection result normal?
YES
>> Replace IPDM E/R. Refer to
PCS-33, "Removal and Installation of IPDM E/R"
.
NO
>> Repair or replace the malfunctioning part.
WIIA1252E
IPDM E/R
Horn relay
Continuity
Connector
Terminal
Connector
Terminal
A: E122
45
B: H-1
1
Yes
IPDM E/R
Ground
Continuity
Connector
Terminal
E122
45
Ground
No
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст