Nissan Frontier D40. Instruction — part 108
BRC-130
< COMPONENT DIAGNOSIS >
[TYPE 2]
C1143, C1144 STEERING ANGLE SENSOR
Always perform calibration of decel G sensor when replacing the ABS actuator and electric unit (control unit).
Refer to
BRC-79, "CALIBRATION OF DECEL G SENSOR : Description"
.
>> END
C1155 BRAKE FLUID LEVEL SWITCH
BRC-131
< COMPONENT DIAGNOSIS >
[TYPE 2]
C
D
E
G
H
I
J
K
L
M
A
B
BRC
N
O
P
C1155 BRAKE FLUID LEVEL SWITCH
Description
INFOID:0000000005548302
The brake fluid level switch converts the brake fluid level to an electric signal and transmits it to the ABS actu-
ator and electric unit (control unit).
DTC Logic
INFOID:0000000005548303
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
1.
CHECK SELF-DIAGNOSIS RESULTS
Check the self-diagnosis results.
Is above displayed on the self-diagnosis display?
YES
>> Proceed to diagnosis procedure. Refer to
BRC-131, "Diagnosis Procedure"
NO
>> Inspection End
Diagnosis Procedure
INFOID:0000000005548304
Regarding Wiring Diagram information, refer to
BRC-154, "Wiring Diagram - BRAKE CONTROL SYSTEM -
WITHOUT HILL DESCENT CONTROL/HILL START ASSIST"
.
1.
CONNECTOR INSPECTION
1.
Disconnect ABS actuator and electric unit (control unit) connector and brake fluid level switch connector.
2.
Check the terminals for deformation, disconnection, looseness or damage.
Is the inspection result normal?
YES
>> GO TO 2
NO
>> Repair or replace as necessary.
2.
CHECK HARNESS BETWEEN BRAKE FLUID LEVEL SWITCH AND ABS ACTUATOR AND ELECTRIC
UNIT (CONTROL UNIT)
1.
Check continuity between ABS actuator and electric unit (control
unit) connector E127 (A) Terminal 28 and brake fluid level switch
connector E21 (B) terminal 1.
2.
Check continuity between ABS actuator and electric unit (control
unit) connector E127 (A) Terminal 28 and ground.
DTC
Display item
Malfunction detected condition
Possible cause
C1155
BR FLUID LEVEL LOW
Brake fluid level is low or communication line between
the ABS actuator and electric unit (control unit) and brake
fluid level switch is open or shorted.
• Harness or connector
• Brake fluid level switch
• Brake fluid level
Self-diagnosis results
BR FLUID LEVEL LOW
ABS actuator and electric unit
(control unit)
Brake fluid level switch
Continuity
Connector
Terminal
Connector
Terminal
E127 (A)
28
E21 (B)
1
Yes
AWFIA0474ZZ
BRC-132
< COMPONENT DIAGNOSIS >
[TYPE 2]
C1155 BRAKE FLUID LEVEL SWITCH
Is the inspection result normal?
YES
>> GO TO 3
NO
>> Repair or replace malfunctioning components.
3.
CHECK BRAKE FLUID LEVEL SWITCH GROUND
Check continuity between brake fluid level switch connector E21 ter-
minal 2 and ground.
Is the inspection result normal?
YES
>> GO TO 4
NO
>> Repair or replace malfunctioning components.
4.
CHECK BRAKE FLUID LEVEL SWITCH
Perform the brake fluid level switch component inspection. Refer to
BRC-132, "Component Inspection"
.
Is the inspection result normal?
YES
>> Perform self-diagnosis again. If the same results appear, replace ABS actuator and electric unit
(control unit). Refer to
BRC-180, "Removal and Installation"
NO
>> Replace brake fluid level switch.
Component Inspection
INFOID:0000000005548305
1.
CHECK BRAKE FLUID LEVEL SWITCH
1.
Turn ignition switch OFF.
2.
Disconnect brake fluid level switch connector.
3.
Check continuity between brake fluid level switch terminals.
Is the inspection result normal?
YES
>> Inspection End
NO
>> Replace brake fluid level switch.
Special Repair Requirement
INFOID:0000000005549038
1.
ADJUSTMENT OF STEERING ANGLE SENSOR NEUTRAL POSITION
Always perform neutral position adjustment for the steering angle sensor when replacing the ABS actuator
and electric unit (control unit). Refer to
BRC-78, "ADJUSTMENT OF STEERING ANGLE SENSOR NEUTRAL
.
>> GO TO 2
2.
CALIBRATION OF DECEL G SENSOR
Always perform calibration of decel G sensor when replacing the ABS actuator and electric unit (control unit).
Refer to
BRC-79, "CALIBRATION OF DECEL G SENSOR : Description"
.
ABS actuator and electric unit (control unit)
—
Continuity
Connector
Terminal
E127 (A)
28
Ground
No
Brake fluid level switch
—
Continuity
Connector
Terminal
E21
2
Ground
Yes
AWFIA0026ZZ
Brake fluid level
switch terminals
Condition
Continuity
1
−
2
Brake fluid reservoir is full.
No
Brake fluid reservoir is empty.
Yes
ALFIA0026ZZ
C1155 BRAKE FLUID LEVEL SWITCH
BRC-133
< COMPONENT DIAGNOSIS >
[TYPE 2]
C
D
E
G
H
I
J
K
L
M
A
B
BRC
N
O
P
>> END
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст