Nissan Frontier D40. Instruction — part 599
EM-128
< ON-VEHICLE MAINTENANCE >
[VQ40DE]
DRIVE BELTS
3.
Rotate the drive belt auto tensioner in the direction of arrow
(loosening direction of tensioner) as shown, using suitable tool.
WARNING:
Avoid placing hand in a location where pinching may occur
if the tool accidentally comes off.
4.
Remove the drive belt.
INSTALLATION
Installation is in the reverse order of removal.
CAUTION:
Make sure belt is securely installed around all pulleys.
Drive Belt Auto Tensioner and Idler Pulley
INFOID:0000000005274318
REMOVAL
1.
Remove the engine room cover. Refer to
EM-138, "Removal and Installation"
2.
Remove air duct and resonator assembly. Refer to
EM-139, "Removal and Installation"
3.
Remove drive belt. Refer to
EM-127, "Removal and Installation"
4.
Remove drive belt auto tensioner and idler pulley.
INSTALLATION
Installation is in the reverse order of removal.
LBIA0428E
AWBIA0861GB
1.
Idler pulley
2.
Drive belt auto tensioner
AIR CLEANER FILTER
EM-129
< ON-VEHICLE MAINTENANCE >
[VQ40DE]
C
D
E
F
G
H
I
J
K
L
M
A
EM
N
P
O
AIR CLEANER FILTER
Exploded View
INFOID:0000000005274319
Removal and Installation
INFOID:0000000005274320
REMOVAL
1.
Unhook clips, and lift air cleaner case (upper).
2.
Remove air cleaner filter.
INSTALLATION
Installation is in the reverse order of removal.
1.
Air cleaner case (lower)
2.
Air cleaner filter
3.
Air cleaner case (upper)
4.
Air duct and resonator
Front
AWBIA0133GB
EM-130
< ON-VEHICLE MAINTENANCE >
[VQ40DE]
SPARK PLUG
SPARK PLUG
Exploded View
INFOID:0000000005274321
Removal and Installation
INFOID:0000000005274322
REMOVAL
1.
Remove engine room cover. Refer to
EM-138, "Removal and Installation"
2.
Remove ignition coil. Refer to
EM-154, "Removal and Installation"
3.
Remove spark plug using suitable tool.
CAUTION:
Do not drop or shock it.
INSPECTION AFTER REMOVAL
• Do not use a wire brush for cleaning.
• If the spark plug tip is covered with carbon, spark plug cleaner may be used.
1.
Ignition coil
2.
Spark plug
PBIC2901E
SEM294A
SMA773C
SPARK PLUG
EM-131
< ON-VEHICLE MAINTENANCE >
[VQ40DE]
C
D
E
F
G
H
I
J
K
L
M
A
EM
N
P
O
• Checking and adjusting spark plug gap is not required between
change intervals.
INSTALLATION
Installation is in the reverse order of removal.
CAUTION:
Do not drop or shock the spark plug.
Cleaner air pressure
: Less than 588 kPa (5.9 bar, 6 kg/cm
2
, 85 psi)
Cleaning time
: Less than 20 seconds
SMA806CA
Make
NGK
Standard type
DILFR5A-11
Gap (nominal)
1.1 mm (0.043 in)
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст