Nissan Pathfinder (2006 year). Instruction — part 317
PARKING, LICENSE PLATE AND TAIL LAMPS
LT-91
C
D
E
F
G
H
I
J
L
M
A
B
LT
2006 Pathfinder
●
through 10A fuse (No. 37, located in the IPDM E/R)
●
through IPDM E/R terminal 57
●
to license plate lamp LH and RH terminal 1
●
to rear combination lamp LH and RH (tail/side marker) terminal 1, and
●
through 10A fuse (No. 36, located in the IPDM E/R)
●
through IPDM E/R terminals 28 and 49
●
to front side marker lamp LH and RH terminal 1
●
to front parking lamp LH and RH terminal 2.
Ground is supplied
●
to front side marker lamp LH and RH terminal 2
●
to front parking lamp LH and RH terminal 3
●
through grounds E9, E15 and E24, and
●
to license plate lamp LH and RH terminal 2
●
through grounds D406 and D504, and
●
to rear combination lamp LH (tail/side marker) terminal 5
●
through grounds B7 and B19, and
●
to rear combination lamp RH (tail/side marker) terminal 5
●
through grounds B117 and B132.
With power and ground supplied, the parking, side marker, license plate and tail lamps illuminate.
COMBINATION SWITCH READING FUNCTION
Refer to
BCS-3, "COMBINATION SWITCH READING FUNCTION"
EXTERIOR LAMP BATTERY SAVER CONTROL
When the combination switch (lighting switch) is in the 1ST (or 2ND) position, and the ignition switch is turned
from ON or ACC to OFF, the battery saver control feature is activated.
Under this condition, the parking, front side marker, license and tail lamps remain illuminated for 5 minutes,
then the parking, front side marker, license plate and tail lamps are turned off.
Exterior lamp battery saver control mode can be changed by the function setting of CONSULT-II.
CAN Communication System Description
EKS00FWQ
Refer to
LT-92
PARKING, LICENSE PLATE AND TAIL LAMPS
2006 Pathfinder
Schematic
EKS00FWR
WKWA4308E
PARKING, LICENSE PLATE AND TAIL LAMPS
LT-93
C
D
E
F
G
H
I
J
L
M
A
B
LT
2006 Pathfinder
Wiring Diagram — TAIL/L —
EKS00FWS
WKWA4231E
LT-94
PARKING, LICENSE PLATE AND TAIL LAMPS
2006 Pathfinder
WKWA3087E
PARKING, LICENSE PLATE AND TAIL LAMPS
LT-95
C
D
E
F
G
H
I
J
L
M
A
B
LT
2006 Pathfinder
WKWA2039E
LT-96
PARKING, LICENSE PLATE AND TAIL LAMPS
2006 Pathfinder
WKWA4342E
PARKING, LICENSE PLATE AND TAIL LAMPS
LT-97
C
D
E
F
G
H
I
J
L
M
A
B
LT
2006 Pathfinder
Terminals and Reference Values for BCM
EKS00FWT
Refer to
BCS-12, "Terminals and Reference Values for BCM"
Terminals and Reference Values for IPDM E/R
EKS00FWU
Refer to
PG-28, "Terminals and Reference Values for IPDM E/R"
.
How to Proceed With Trouble Diagnosis
EKS00FWV
1.
Confirm the symptom or customer complaint.
2.
Understand operation description and function description. Refer to
.
3.
Carry out the Preliminary Check. Refer to
4.
Check symptom and repair or replace the cause of malfunction.
5.
Do the parking, front side marker, license and tail lamps operate normally? If YES: GO TO 6. If NO: GO
TO 4.
6.
Inspection End.
Preliminary Check
EKS00FWW
CHECK POWER SUPPLY AND GROUND CIRCUIT
BCS-16, "BCM Power Supply and Ground Circuit Check"
and
PG-30, "IPDM E/R Power/Ground Cir-
.
CONSULT-II Functions
EKS00FWX
Refer to
LT-12, "CONSULT-II Function (BCM)"
in HEADLAMP (FOR USA).
Refer to
LT-15, "CONSULT-II Function (IPDM E/R)"
in HEADLAMP (FOR USA).
Parking, Side Marker, License Plate and/or Tail Lamps Do Not Illuminate
EKS00FWY
1.
CHECK COMBINATION SWITCH INPUT SIGNAL
With CONSULT-II
Select "BCM" on CONSULT-II. With "HEAD LAMP" data monitor,
make sure "LIGHT SW 1ST" turns ON-OFF linked with operation of
lighting switch.
Without CONSULT-II
Refer to
LT-82, "Combination Switch Inspection"
OK or NG
OK
>> GO TO 2.
NG
>> Check lighting switch. Refer to
When lighting switch is in
1ST position
: LIGHT SW 1ST ON
SKIA5956E
LT-98
PARKING, LICENSE PLATE AND TAIL LAMPS
2006 Pathfinder
2.
ACTIVE TEST
With CONSULT-II
1.
Select "IPDM E/R" on CONSULT-II, and select "ACTIVE TEST"
on "SELECT DIAG MODE" screen.
2.
Select "EXTERNAL LAMPS" on "SELECT TEST ITEM" screen.
3.
Touch "TAIL" on "ACTIVE TEST" screen.
4.
Make sure parking, front side marker, license plate and tail lamp
operation.
Without CONSULT-II
1.
Start auto active test. Refer to
2.
Make sure parking, front side marker, license plate and tail lamp operation.
OK or NG
OK
>> GO TO 3.
NG
>> GO TO 4.
3.
CHECK IPDM E/R
1.
Select "IPDM E/R" on CONSULT-II, and select "DATA MONI-
TOR" on "SELECT DIAG MODE" screen.
2.
Make sure "TAIL&CLR REQ" turns ON when lighting switch is in
1ST position.
OK or NG
OK
>> Replace IPDM E/R. Refer to
NG
BCS-27, "Removal and Installa-
.
Parking, front side marker, license plate and tail
lamp should operate
Parking, front side marker, license plate and tail
lamp should operate
WKIA1438E
When lighting switch is in
1ST position
: TAIL&CLR REQ ON
SKIA5958E
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст