Nissan Versa Note. Instruction — part 62
AV-240
< REMOVAL AND INSTALLATION >
[NAVIGATION]
AV CONTROL UNIT
REMOVAL AND INSTALLATION
AV CONTROL UNIT
Removal and Installation
INFOID:0000000009460041
REMOVAL
CAUTION:
• Remove battery terminal and AV control unit after a lapse of 30 seconds or more after turning the
ignition switch OFF.
• Before replacing AV control unit, perform "READ CONFIGURATION" to save current vehicle specifi-
cation. Refer to
AV-178, "CONFIGURATION (AV CONTROL UNIT) : Description"
NOTE:
After the ignition switch is turned OFF, the AV control unit continues operating for approximately 30 seconds.
Therefore, data corruption may occur if battery voltage is cut off within 30 seconds.
1. Remove the battery negative terminal. Refer to
PG-67, "Removal and Installation (Battery)"
.
2. Remove cluster lid C. Refer to
IP-22, "Removal and Installation"
3. Remove the AV control unit screws (A) and partially remove the
AV control unit (1).
4. Disconnect the harness connectors from the AV control unit and remove.
5. Remove the AV control unit bracket screws (A) and the AV con-
trol unit bracket (1) from each side of the AV control unit (if nec-
essary).
INSTALLATION
Installation is in the reverse order of removal.
CAUTION:
• When replacing AV control unit, perform "WRITE CONFIGURATION". Refer to
TION (AV CONTROL UNIT) : Work Procedure"
.
AWNIA3071ZZ
AWNIA3072ZZ
AWNIA3073ZZ
AV
AV CONTROL UNIT
AV-241
< REMOVAL AND INSTALLATION >
[NAVIGATION]
C
D
E
F
G
H
I
J
K
L
M
B
A
O
P
• Perform camera image calibration. Refer to
AV-181, "CALIBRATING CAMERA IMAGE (AROUND
AV-242
< REMOVAL AND INSTALLATION >
[NAVIGATION]
FRONT DOOR SPEAKER
FRONT DOOR SPEAKER
Removal and Installation
INFOID:0000000009541288
REMOVAL
1. Remove the front door finisher. Refer to
INT-15, "Removal and Installation"
2. Disconnect the harness connector from front door speaker.
3. Remove the front door speaker screws (A).
4. Remove the front door speaker (1).
INSTALLATION
Installation is in the reverse order of removal.
AWNIA3062ZZ
AV
REAR DOOR SPEAKER
AV-243
< REMOVAL AND INSTALLATION >
[NAVIGATION]
C
D
E
F
G
H
I
J
K
L
M
B
A
O
P
REAR DOOR SPEAKER
Removal and Installation
INFOID:0000000009541289
REMOVAL
1. Remove the rear door finisher. Refer to
INT-18, "Removal and Installation"
.
2. Disconnect the harness connector from the rear door speaker.
3. Remove the rear door speaker screws (A).
4. Remove the rear door speaker (1).
INSTALLATION
Installation is in the reverse order of removal.
AWNIA3089ZZ
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст