Nissan Versa Note. Instruction — part 864

C1704, C1705, C1706, C1707 LOW TIRE PRESSURE

WT-25

< DTC/CIRCUIT DIAGNOSIS >

C

D

F

G

H

I

J

K

L

M

A

B

WT

N

O

P

DTC/CIRCUIT DIAGNOSIS

C1704, C1705, C1706, C1707 LOW TIRE PRESSURE

DTC Logic

INFOID:0000000009443175

DTC DETECTION LOGIC

DTC CONFIRMATION PROCEDURE

1.

PERFORM SELF DIAGNOSTIC RESULT

With CONSULT

1. Turn the ignition switch ON.

2. Check the tire pressure for all wheels and adjust to the specified value. Refer to

WT-50, "Tire Air Pres-

sure"

.

3. Perform “SELF DIAGNOSTIC RESULT”.
Is DTC “C1704”, “C1705”, “C1706”, or “C1707” detected?

YES

>> Proceed to

WT-25, "Diagnosis Procedure"

.

NO

>> Inspection End.

Diagnosis Procedure

INFOID:0000000009443176

1.

CHECK DATA MONITOR

With CONSULT

1. Drive for 3 minutes at a speed of 40 km/h (25 MPH) or more, then drive normally for 10 minutes.

2. Stop the vehicle.

3. On “DATA MONITOR” select “AIR PRESS FL”, “AIR PRESS FR”, “AIR PRESS RR” and “AIR PRESS RL”.

4. Within 5 minutes after vehicle stopped, check that the tire pressures are within specification. Refer to

WT-

50, "Tire Air Pressure"

.

Is the inspection result normal?

YES

>> Inspection End.

NO

>> Repair or replace error-detected parts.

DTC

Display item

Malfunction detected condition

Possible causes

C1704

LOW PRESSURE FL

Front LH tire pressure drops to 182.7 kPa (1.9 kg/cm

2

, 26 psi) or less.

Low tire pressure

C1705

LOW PRESSURE FR

Front RH tire pressure drops to 182.7 kPa (1.9 kg/cm

2

, 26 psi) or less.

C1706

LOW PRESSURE RR

Rear RH tire pressure drops to 182.7 kPa (1.9 kg/cm

2

, 26 psi) or less.

C1707

LOW PRESSURE RL

Rear LH tire pressure drops to 182.7 kPa (1.9 kg/cm

2

, 26 psi) or less.

Monitor item

Displayed value

AIR PRESS FL

Approximately equal to the indication on tire gauge value for front LH tire

AIR PRESS FR

Approximately equal to the indication on tire gauge value for front RH tire

AIR PRESS RR

Approximately equal to the indication on tire gauge value for rear RH tire

AIR PRESS RL

Approximately equal to the indication on tire gauge value for rear LH tire

WT-26

< DTC/CIRCUIT DIAGNOSIS >

C1708, C1709, C1710, C1711 TRANSMITTER (NO DATA)

C1708, C1709, C1710, C1711 TRANSMITTER (NO DATA)

DTC Logic

INFOID:0000000009443177

DTC DETECTION LOGIC

DTC CONFIRMATION PROCEDURE

1.

PERFORM SELF DIAGNOSTIC RESULT

With CONSULT

1. Drive for 3 minutes at a speed of 40 km/h (25 MPH) or more, then drive normally for 10 minutes.

2. Stop the vehicle.

3. Perform “SELF DIAGNOSTIC RESULT”.
Is DTC “C1708”, “C1709”, “C1710” or “C1711” detected?

YES

>> Proceed to

WT-26, "Diagnosis Procedure"

.

NO

>> Inspection End.

Diagnosis Procedure

INFOID:0000000009443178

Regarding Wiring Diagram information, refer to

WT-15, "Wiring Diagram - With Intelligent Key"

.

1.

CHECK DATA MONITOR

With CONSULT

1. Drive for 3 minutes at a speed of 40 km/h (25 MPH) or more, then drive normally for 10 minutes.

2. Stop the vehicle.

3. On “DATA MONITOR” select “AIR PRESS FL”, “AIR PRESS FR”, “AIR PRESS RR” and “AIR PRESS RL”.

4. Within 5 minutes after vehicle is stopped, read the values displayed on CONSULT.
Are all tire pressures displayed 0 kPa (psi)?

YES

>> GO TO 2.

NO

>> GO TO 5.

2.

CHECK REMOTE KEYLESS ENTRY RECEIVER POWER CIRCUIT

Check voltage between remote keyless entry receiver connector and ground.

Is the inspection result normal?

YES

>> GO TO 3.

NO

>> Repair or replace harness or connectors.

3.

CHECK REMOTE KEYLESS ENTRY RECEIVER SIGNAL CIRCUIT

DTC

Display Item

Malfunction detected condition

Possible causes

C1708

[NO DATA] FL

Tire pressure data signal from the front LH wheel
transmitter cannot be detected.

• Harness or connector connec-

tion malfunction

• Transmitter ID registration in-

complete

• Transmitter malfunction

C1709

[NO DATA] FR

Tire pressure data signal from the front RH wheel
transmitter cannot be detected.

C1710

[NO DATA] RR

Tire pressure data signal from the rear RH wheel
transmitter cannot be detected.

C1711

[NO DATA] RL

Tire pressure data signal from the rear LH wheel
transmitter cannot be detected.

Remote keyless entry receiver

Ground

Voltage

(Approx.)

Connector

Terminal

M94 (with Intelligent Key system)

1

—

Battery voltage

M23 (without Intelligent Key system)

4

C1708, C1709, C1710, C1711 TRANSMITTER (NO DATA)

WT-27

< DTC/CIRCUIT DIAGNOSIS >

C

D

F

G

H

I

J

K

L

M

A

B

WT

N

O

P

1. Turn the ignition switch OFF.

2. Disconnect BCM and remote keyless entry receiver connectors.

3. Check continuity between BCM and remote keyless entry receiver connectors.

4. Check continuity between BCM connector and ground.

Is the inspection result normal?

YES

>> GO TO 4.

NO

>> Repair or replace the malfunctioning harness or connector.

4.

CHECK REMOTE KEYLESS ENTRY RECEIVER GROUND CIRCUIT

Check continuity between BCM and remote keyless entry receiver connectors.

Is the inspection result normal?

YES

>> GO TO 5.

NO

>> Repair or replace the malfunctioning harness or connector.

5.

TRANSMITTER ID REGISTRATION

Perform transmitter ID registration. Refer to

WT-22, "Work Procedure"

.

Is transmitter ID registration completed?

YES

>> GO TO 6.

NO

>> Replace applicable transmitter. Refer to

WT-46, "Removal and Installation"

.

6.

CHECK TIRE PRESSURE SIGNAL

With CONSULT

1. Drive for 3 minutes at a speed of 40 km/h (25 MPH) or more, then drive normally for 10 minutes.

2. Stop the vehicle.

3. On “DATA MONITOR” select “AIR PRESS FL”, “AIR PRESS FR”, “AIR PRESS RR” and “AIR PRESS RL”.

4. Within 5 minutes after vehicle stopped, check that the tire pressures are within specification. Refer to

WT-

50, "Tire Air Pressure"

.

Is the inspection result normal?

YES

>> Inspection End.

NO

>> Replace the BCM. Refer to

BCS-70, "Removal and Installation"

(with I-Key) or

BCS-127,

"Removal and Installation"

(without I-Key).

BCM

Remote keyless entry receiver

Continuity

Connector

Terminal

Connector

Terminal

M97 (with Intelligent Key system)

38

M94 (with Intelligent Key system)

2

Yes

M18 (without Intelligent Key system)

20

M23 (without Intelligent Key system)

BCM

—

Continuity

Connector

Terminal

M97 (with Intelligent Key system)

38

Ground

No

M18 (without Intelligent Key system)

20

BCM

Remote keyless entry receiver

Continuity

Connector

Terminal

Connector

Terminal

M97 (with Intelligent Key system)

18

M94 (with Intelligent Key system)

4

Yes

M18 (without Intelligent Key system)

M23 (without Intelligent Key system)

1

Monitor item

Displayed value

AIR PRESS FL

Approximately equal to the indication on tire gauge value for front LH tire

AIR PRESS FR

Approximately equal to the indication on tire gauge value for front RH tire

AIR PRESS RR

Approximately equal to the indication on tire gauge value for rear RH tire

AIR PRESS RL

Approximately equal to the indication on tire gauge value for rear LH tire

WT-28

< DTC/CIRCUIT DIAGNOSIS >

C1716, C1717, C1718, C1719 TRANSMITTER (PRESSURE DATA)

C1716, C1717, C1718, C1719 TRANSMITTER (PRESSURE DATA)

DTC Logic

INFOID:0000000009443179

DTC DETECTION LOGIC

DTC CONFIRMATION PROCEDURE

1.

PERFORM SELF DIAGNOSTIC RESULT

With CONSULT

1. Turn the ignition switch ON.

2. Check the tire pressure for all wheels and adjust to the specified value. Refer to

WT-50, "Tire Air Pres-

sure"

.

3. Perform “SELF DIAGNOSTIC RESULT”.
Is DTC “C1716”, “C1717”, “C1718”, or “C1719” detected?

YES

>> Proceed to

WT-28, "Diagnosis Procedure"

.

NO

>> Inspection End.

Diagnosis Procedure

INFOID:0000000009443180

1.

CHECK TIRE PRESSURE

Check the air pressure of all wheels. Refer to pressure observed during “DTC CONFIRMATION PROCE-

DURE”.
Is the inspection result normal?

YES

>> Replace the DTC-detected malfunctioning transmitter. Refer to

WT-46, "Removal and Installa-

tion"

.

NO

>> GO TO 2.

2.

CHECK TIRE PRESSURE SIGNAL

With CONSULT

1. Perform transmitter ID registration for all wheels. Refer to

WT-22, "Work Procedure"

.

2. Drive for 3 minutes at a speed of 40 km/h (25 MPH) or more, then drive normally for 10 minutes.

3. Stop the vehicle.

4. On “DATA MONITOR” select “AIR PRESS FL”, “AIR PRESS FR”, “AIR PRESS RR” and “AIR PRESS RL”.

5. Within 5 minutes after vehicle is stopped, read the values displayed on CONSULT.
Are tire pressures displayed as 438.6 kPa (4.47 kg/cm

2

, 63.6 psi)?

YES

>> Replace transmitter for the tire that displayed pressure as 438.6 kPa (4.47 kg/cm

2

, 63.6 psi).

Refer to

WT-46, "Removal and Installation"

.

NO

>> Perform “DTC CONFIRMATION PROCEDURE” again. Refer to

WT-28, "DTC Logic"

.

DTC

Display Item

Malfunction detected condition

Possible causes

C1716

[PRESSDATA ERR] FL

Malfunction in the tire pressure data from the
front LH wheel transmitter.

• Transmitter ID registration in-

complete

• Transmitter malfunction

C1717

[PRESSDATA ERR] FR

Malfunction in the tire pressure data from the
front RH wheel transmitter.

C1718

[PRESSDATA ERR] RR

Malfunction in the tire pressure data from the
rear RH wheel transmitter.

C1719

[PRESSDATA ERR] RL

Malfunction in the tire pressure data from the
rear LH wheel transmitter.