Nissan Versa Note. Instruction — part 725
VEHICLE SECURITY INDICATOR
SEC-179
< DTC/CIRCUIT DIAGNOSIS >
[WITHOUT INTELLIGENT KEY SYSTEM]
C
D
E
F
G
H
I
J
L
M
A
B
SEC
N
O
P
4. Check continuity between BCM connector M18 terminal 23 and ground.
Is the inspection result normal?
YES
>> Check the following:
• 10A fuse [No. 8, located in fuse block (J/B)]
• Harness for open or short between security indicator lamp and fuse
NO
>> Repair or replace harness.
23 - Ground
: Continuity should not exist.
SEC-180
< SYMPTOM DIAGNOSIS >
[WITHOUT INTELLIGENT KEY SYSTEM]
NISSAN VEHICLE IMMOBILIZER SYSTEM-NATS SYMPTOMS
SYMPTOM DIAGNOSIS
NISSAN VEHICLE IMMOBILIZER SYSTEM-NATS SYMPTOMS
Symptom Table
INFOID:0000000009521034
NOTE:
• Before performing the diagnosis in the following table, check “
• Check that vehicle is under the condition shown in “Conditions of vehicle” before starting diagnosis, and
check each symptom.
• If the following symptoms are detected, check systems shown in the “Diagnosis/service procedure” column
in this order.
CONDITIONS OF VEHICLE (OPERATING CONDITIONS)
• Mechanical key is not inserted into key cylinder.
• Ignition knob switch is not depressed.
Symptom
Diagnosis/service procedure
Reference page
Security indicator does not turn ON or flash.
1. Check vehicle security indicator
2. Check Intermittent Incident
NATS ANTENNA AMP.
SEC-181
< REMOVAL AND INSTALLATION >
[WITHOUT INTELLIGENT KEY SYSTEM]
C
D
E
F
G
H
I
J
L
M
A
B
SEC
N
O
P
REMOVAL AND INSTALLATION
NATS ANTENNA AMP.
Removal and Installation
INFOID:0000000009521035
REMOVAL
1. Remove combination switch. Refer to
BCS-71, "Removal and Installation"
2. Remove the NATS antenna amp bolt (A).
3. Disconnect the harness connector (B) from the NATS antenna
amp. (1) and remove.
INSTALLATION
Installation is in the reverse order of removal.
NOTE:
• If NATS antenna amp. is not installed correctly, NVIS (NATS) system will not operate properly and “SELF-
DIAG RESULTS" on CONSULT screen will show “LOCK MODE” or "CHAIN OF IMMU-KEY".
• Initialization is not necessary when only the NATS antenna amp. is replaced with a new one.
AWKIA2524ZZ
SEC-182
< REMOVAL AND INSTALLATION >
[WITHOUT INTELLIGENT KEY SYSTEM]
REMOTE KEYLESS ENTRY RECEIVER
REMOTE KEYLESS ENTRY RECEIVER
Removal and Installation
INFOID:0000000009541252
REMOVAL
1. Remove the glove box. Refer to
IP-25, "Removal and Installation"
.
2. Disconnect the harness connector (A) from remote keyless entry
receiver (1).
3. Remove screw (B) and remove remote keyless entry receiver.
INSTALLATION
Installation is in the reverse order of removal.
ALKIA3178ZZ
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст