Nissan Versa Note. Instruction — part 33
AV-124
< REMOVAL AND INSTALLATION >
[DISPLAY AUDIO]
BLUETOOTH® ANTENNA
BLUETOOTH® ANTENNA
Removal and Installation
INFOID:0000000009541254
REMOVAL
1. Remove the luggage side lower finisher (RH). Refer to
INT-34, "LUGGAGE SIDE LOWER FINISHER :
.
2. Disconnect the Bluetooth® antenna harness connector from the Bluetooth® control unit.
3. Remove the Bluetooth® antenna screws (A) and the Bluetooth®
antenna (1).
INSTALLATION
Installation is in the reverse order of removal.
AWNIA3095ZZ
AV
STEERING SWITCH
AV-125
< REMOVAL AND INSTALLATION >
[DISPLAY AUDIO]
C
D
E
F
G
H
I
J
K
L
M
B
A
O
P
STEERING SWITCH
Removal and Installation
INFOID:0000000009541280
REMOVAL
1. Remove the steering wheel. Refer to
ST-8, "Removal and Installation"
2. Remove the steering wheel rear finisher (1) by releasing pawls
(A).
3. Remove the steering wheel audio control switch screws (A) from
the back of the steering wheel.
4. Remove the steering wheel audio control switches from the steering wheel.
INSTALLATION
Installation is in the reverse order of removal.
AWNIA3063ZZ
AWNIA3064ZZ
AV-126
< REMOVAL AND INSTALLATION >
[DISPLAY AUDIO]
MICROPHONE
MICROPHONE
Removal and Installation
INFOID:0000000009541281
REMOVAL
1. Remove the microphone finisher from the headlining by releas-
ing pawls (A) using a suitable tool.
2. Disconnect the harness connector from microphone and remove.
3. Separate the microphone from the finisher by releasing pawls
(A) using a suitable tool.
INSTALLATION
Installation is in the reverse order of removal.
NOTE:
Make sure to align the rib on the finisher with the slot in the microphone.
Make sure to install the microphone with the arrows pointing toward the RH side of the vehicle.
AWNIA3153ZZ
AWNIA3154ZZ
AV
ROD ANTENNA
AV-127
< REMOVAL AND INSTALLATION >
[DISPLAY AUDIO]
C
D
E
F
G
H
I
J
K
L
M
B
A
O
P
ROD ANTENNA
Exploded View
INFOID:0000000009541282
Removal and Installation
INFOID:0000000009541283
REMOVAL
1. Lower the rear portion of the headlining. Refer to
INT-31, "Removal and Installation"
2. Disconnect the harness connectors from the antenna (satellite radio model shown).
3. Remove the antenna nut (A) and remove the antenna.
INSTALLATION
Installation is in the reverse order of removal.
CAUTION:
If the antenna nut is tightened less than the specified torque this will lower the sensitivity of the
antenna. If the antenna nut is tightened more than the specified torque this will deform the roof panel.
AWNIA3124ZZ
1. Antenna rod
2. Antenna base
A. Antenna nut
AWNIA3115ZZ
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст