Nissan Versa Note. Instruction — part 157
CHG
GENERATOR
CHG-29
< REMOVAL AND INSTALLATION >
C
D
E
F
G
H
I
J
K
L
B
A
O
P
N
REMOVAL AND INSTALLATION
GENERATOR
Exploded View
INFOID:0000000009395307
Removal and Installation
INFOID:0000000009395308
REMOVAL
1. Disconnect the battery cable from the negative terminal. Refer to
2. Remove the radiator core support upper.
DLK-139, "RADIATOR CORE SUPPORT UPPER : Removal
(with intelligent key system) or
DLK-265, "RADIATOR CORE SUPPORT UPPER :
(without intelligent key system).
3. Remove drive belt. Refer to
.
4. Disconnect generator harness connector.
5. Remove “B” terminal nut and disconnect “B” terminal harness.
6. Remove the generator bolts.
7. Remove the generator.
CAUTION:
Be careful not to damage surrounding parts when removing generator from the vehicle.
8. Remove bolts and remove generator bracket if necessary.
INSTALLATION
1.
Generator bracket
2.
Tensioner Idler pulley
3.
Generator
4.
“B” terminal harness
5.
Generator harness connector
AWGIA0293ZZ
CHG-30
< REMOVAL AND INSTALLATION >
GENERATOR
1. Install the generator bracket (if removed), using the following
procedure.
a. Temporarily tighten bolt (1).
b. Temporarily tighten bolt (2).
c.
Tighten bolts to specification in numerical order as shown.
2. Install the generator using the following procedure.
a. Temporarily tighten the generator bolts in order from the lower to the upper.
b. Tighten the generator bolts to the specification starting with the top bolt.
c.
Install “B” terminal harness and "B" terminal nut.
CAUTION:
Be sure to tighten "B" terminal nut carefully.
Installation of the remaining components is the reverse order of removal.
JMMIA0463ZZ
CHG
SERVICE DATA AND SPECIFICATIONS (SDS)
CHG-31
< SERVICE DATA AND SPECIFICATIONS (SDS)
C
D
E
F
G
H
I
J
K
L
B
A
O
P
N
SERVICE DATA AND SPECIFICATIONS (SDS)
SERVICE DATA AND SPECIFICATIONS (SDS)
Generator
INFOID:0000000009395309
* : Always check with the Parts Department for the latest parts information.
Model*
A002TJ1791ZC
Manufacturer
Mitsubishi
Nominal rating
13.5V - 110A
Ground polarity
Negative
Minimum revolution under no-load
1,000 rpm
Hot output current (When 13.5 V is applied)
More than 27A/1,300 rpm
More than 95A/2,500 rpm
More than 116A/5,000 rpm
Regulated output voltage
14.1 - 14.7V @20
°C (68°F)
Adjustment range of power generation voltage variable control
11.4 - 15.6V
CL-1
TRANSMISSION & DRIVELINE
C
E
F
G
H
I
J
K
L
M
SECTION
CL
A
B
CL
N
O
P
CONTENTS
CLUTCH
PRECAUTION . . . . . . . . . . . ...
PRECAUTIONS . . . . . . . . . . . . ...
General Precautions . . . . . . . . . . . .....
PREPARATION . . . . . . . . . . .
PREPARATION . . . . . . . . . . . . ...
Commercial Service Tools . . . . . . . . . ....
SYMPTOM DIAGNOSIS . . . . . . . ...
NOISE, VIBRATION AND HARSHNESS
(NVH) TROUBLESHOOTING . . . . . . . .
NVH Troubleshooting Chart . . . . . . . . . ..
PERIODIC MAINTENANCE . . . . . . ..
CLUTCH PEDAL . . . . . . . . . . . . .
Inspection and Adjustment . . . . . . . . . ....
CLUTCH FLUID . . . . . . . . . . . . ...
Inspection . . . . . . . . . . . . . . . . ..
Draining . . . . . . . . . . . . . . . . .....
Refilling . . . . . . . . . . . . . . . . .....
Air Bleeding . . . . . . . . . . . . . . . ...
REMOVAL AND INSTALLATION . . . ...
CLUTCH PEDAL . . . . . . . . . . . .
Exploded View . . . . . . . . . . . . . .
Removal and Installation . . . . . . . . . . .
Inspection and Adjustment . . . . . . . . . ..
CLUTCH MASTER CYLINDER . . . . . .
Exploded View . . . . . . . . . . . . . . .
Removal and Installation . . . . . . . . . . .
Inspection and Adjustment . . . . . . . . . ..
CLUTCH PIPING . . . . . . . . . . . ...
Exploded View . . . . . . . . . . . . . . .
Hydraulic Layout . . . . . . . . . . . . . ..
Removal and Installation . . . . . . . . . . .
Inspection and Adjustment . . . . . . . . . ..
UNIT REMOVAL AND INSTALLATION . ..
CSC (CONCENTRIC SLAVE CYLINDER) . ...
Exploded View . . . . . . . . . . . . . . .
Removal and Installation . . . . . . . . . . .
Inspection and Adjustment . . . . . . . . . ..
CLUTCH DISC AND CLUTCH COVER . . .
Exploded View . . . . . . . . . . . . . . .
Removal and Installation . . . . . . . . . . .
Inspection . . . . . . . . . . . . . . . .
SERVICE DATA AND SPECIFICATIONS
(SDS) . . . . . . . . . . . . . . .
SERVICE DATA AND SPECIFICATIONS
(SDS) . . . . . . . . . . . . . . . . .
General Specifications . . . . . . . . . . . .
Clutch Pedal . . . . . . . . . . . . . . .
Clutch Disc . . . . . . . . . . . . . . . ..
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст