Nissan Versa Note. Instruction — part 142
BRM-20
< REMOVAL AND INSTALLATION >
BODY SEALING
ALKIA3142ZZ
Front
REPLACEMENT OPERATIONS
BRM-21
< REMOVAL AND INSTALLATION >
C
D
E
F
G
H
I
J
L
M
A
B
BRM
N
O
P
REPLACEMENT OPERATIONS
Description
INFOID:0000000009345082
This section is prepared for technicians who have attained a high level of skill and experience in repairing col-
lision-damaged vehicles and also use modern service tools and equipment. Persons unfamiliar with body
repair techniques should not attempt to repair collision-damaged vehicles by using this section.
Technicians are also encouraged to read Body Repair Instruction (Fundamentals) in order to ensure that the orig-
inal functions and quality of the vehicle can be maintained. The Body Repair Instruction (Fundamentals) contains
additional information, including cautions and warning, that are not including in this instruction. Technicians
should refer to both instructions to ensure proper repairs.
Please note that these information are prepared for worldwide usage, and as such, certain procedures might
not apply in some regions or countries.
BRM-22
< REMOVAL AND INSTALLATION >
REPLACEMENT OPERATIONS
The symbols used in this section for cutting and welding / brazing operations are shown below.
PIIA0149E
REPLACEMENT OPERATIONS
BRM-23
< REMOVAL AND INSTALLATION >
C
D
E
F
G
H
I
J
L
M
A
B
BRM
N
O
P
• Front pillar butt joint can be determined anywhere within shaded
area (A) as shown in the figure. The best location for the butt joint
is at position (B) due to the construction of the vehicle. Refer to the
front pillar section.
• Determine cutting position and record distance from the locating
indent (A). Use this distance when cutting the service part. Cut
outer front pillar over 60 mm above inner front pillar cut position
(B).
• Prepare a cutting jig to make outer pillar easier to cut. Also, this will
permit service part to be accurately cut at joint position.
• An example of cutting operation using a cutting jig is as follows.
1. Mark cutting lines.
A: Cut position of outer pillar
B: Cut position of inner pillar
2. Align cutting line with notch on jig. Clamp jig to pillar.
3. Cut outer pillar along groove of jig. (At position A)
4. Remove jig and cut remaining portions.
5. Cut inner pillar at position in same manner.
PIIA0150E
PIIA0151E
PIIA0152E
PIIA0153E
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст