Nissan Almera Tino V10. Instruction — part 23
SFE641A
8.
From rear left area of fuel tank, remove filler hose, vent hose,
and EVAP hose.
CAUTION:
To prevent fuel from flowing out, install a blind cap immedi-
ately after the fuel hose is disconnected.
SFE642A
9.
Remove exhaust center tube.
SFE643A
10. Remove heat insulators from fuel tank side.
SFE644A
11. Set a suitable transmission jack under fuel tank.
12. Remove fuel tank mounting band bolts while supporting fuel
tank.
13. Remove fuel tank.
NFE072
INSTALLATION
NLFE0016S02
To install, reverse the removal procedure. Connect the quick con-
nector as follows:
I
Insert tube into the center of the connector until you hear a
click.
GI
MA
EM
LC
EC
CL
MT
AT
AX
SU
BR
ST
RS
BT
HA
SC
EL
IDX
FUEL SYSTEM
YD
Fuel Tank (Cont’d)
FE-21
NFE073
After connecting quick connector, make sure the connection is
firmly made using the following method.
I
Pull on the fuel tube and connector to make sure they are firmly
connected.
I
Start the engine, increase engine speed and verify that there
are no leaks.
Fuel Level Sensor Unit
NLFE0032
NFE074
JFE613A
REMOVAL
NLFE0032S01
1.
Disconnect battery ground cable.
2.
Open fuel filler lid and filler cap.
3.
Remove rear seat cushion. Refer to BT-48, “Removal and
Installation”.
4.
Remove inspection hole cover under the rear seat.
FUEL SYSTEM
YD
Fuel Tank (Cont’d)
FE-22
SFE639A
5.
Disconnect electrical connector.
6.
Disconnect the quick connectors.
I
For disconnect of quick connectors, refer to step 7. of “Fuel
Tank Removal”.
SFE376A
7.
Remove lock ring using a lock ring socket (SST).
SFE648AA
8.
Pull out the fuel level sensor unit and fuel pump.
I
Do not damage the arm of the fuel level sensor unit.
INSTALLATION
NLFE0032S02
Installation is in reverse order of removal.
GI
MA
EM
LC
EC
CL
MT
AT
AX
SU
BR
ST
RS
BT
HA
SC
EL
IDX
FUEL SYSTEM
YD
Fuel Level Sensor Unit (Cont’d)
FE-23
SMA211A
Checking Exhaust System
NLFE0022
Check
exhaust
pipes,
muffler
and
mounting
for
improper
attachment, leaks, cracks, damage, chafing or deterioration.
SEF180A
Removal and Installation
NLFE0018
CAUTION:
I
Always replace exhaust gaskets with new ones when
reassembling. If gasket remains on flange surface, scrape
off completely as shown at left.
I
With engine running, check all tube connections for
exhaust gas leaks, and entire system for unusual noises.
I
Check to ensure that mounting brackets and mounting
insulators are installed properly and free from undue
stress. Improper installation could result in excessive
noise or vibration.
I
Be sure to use genuine exhaust system parts which are
designed
especially
for
heat
resistance,
corrosion
resistance, and shape.
I
Perform the operation with the exhaust system fully
cooled down because the system will be heated just after
the engine stops.
I
Be careful not to cut your hand on the insulator edge.
EXHAUST SYSTEM
YD
Checking Exhaust System
FE-24
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст