Nissan Almera Tino V10. Instruction — part 701
Component Parts and Harness Connector
Location
NLEL0441
YEL328E
System Description
NLEL0442
UNIFIED CONTROL METER
NLEL0442S01
I
Speedometer, odo/trip meter, tachometer, fuel gauge and water temperature gauge are controlled totally
by control unit built-in combination meter.
I
Digital meter is adopted for odo/trip meter.*
*The record of the odo meter is kept even if the battery cable is disconnected. The record of the trip meter
is erased when the battery cable is disconnected.
I
Odo/trip meter segment can be checked in diagnosis mode.
I
Meter/gauge can be checked in diagnosis mode.
HOW TO CHANGE THE DISPLAY FOR ODO/TRIP METER
NLEL0442S02
YEL329E
NOTE:
Turn ignition switch to the “ON” position to operate odo/trip meter.
METERS AND GAUGES
Component Parts and Harness Connector Location
EL-100
POWER SUPPLY AND GROUND CIRCUIT
=NLEL0442S03
Power is supplied at all times
I
through 10A fuse [No. 12, located in the fuse block (J/B)]
I
to combination meter terminal 3.
With the ignition switch in the ON or START position, power is supplied
I
through 10A fuse [No. 30, located in the fuse block (J/B)]
I
to combination meter terminal 2.
With the ignition switch in the ACC or ON position, power is supplied
I
through 10A fuse [No. 1, located in the fuse block (J/B)]
I
to combination meter terminal 5.
Ground is supplied
I
through body grounds M28, M48, M109 (QG engine) or F51 (YD engine)
I
to combination meter terminal 7.
WATER TEMPERATURE GAUGE
NLEL0442S04
The water temperature gauge indicates the engine coolant temperature.
ECM provides a engine coolant temperature signal to combination meter for water temperature gauge via CAN
communication line.
TACHOMETER
NLEL0442S05
The tachometer indicates engine speed in revolution per minutes (rpm). ECM provides an engine speed sig-
nal to combination meter for tachometer via CAN communication line.
FUEL GAUGE
NLEL0442S06
The fuel gauge indicates the approximate fuel level in the fuel tank.
The fuel gauge is regulated by a variable ground signal supplied
I
from body grounds M28, M48, M109 (QG engine) or F51 (YD engine)
I
through terminals 4 and 26 of combination meter,
I
through terminal 1 of the fuel level sensor unit and
I
through terminal 4 of the fuel level sensor unit
I
to combination meter terminal 25 for the fuel gauge.
SPEEDOMETER
NLEL0442S07
The combination meter receives a signal from the ABS actuator and electric unit (control unit) via CAN com-
munication line. The speedometer converts the signal into the vehicle speed displayed.
GI
MA
EM
LC
EC
FE
CL
MT
AT
AX
SU
BR
ST
RS
BT
HA
SC
IDX
METERS AND GAUGES
System Description (Cont’d)
EL-101
Combination Meter
NLEL0443
CHECK
NLEL0443S01
YEL091E
METERS AND GAUGES
Combination Meter
EL-102
Schematic
NLEL0444
YEL092E
GI
MA
EM
LC
EC
FE
CL
MT
AT
AX
SU
BR
ST
RS
BT
HA
SC
IDX
METERS AND GAUGES
Schematic
EL-103
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст