Nissan Murano. Instruction — part 128
AV-290
< REMOVAL AND INSTALLATION >
[BOSE AUDIO WITHOUT NAVIGATION]
REAR VIEW CAMERA
REAR VIEW CAMERA
Exploded View
INFOID:0000000009721819
Removal and Installation
INFOID:0000000009721820
REMOVAL
1.
Remove back door finisher inner. Refer to
2.
Remove finisher.
3.
Remove rear view camera screws, disconnect rear view camera connector and remove rear view camera
from back door assembly.
INSTALLATION
Install in the reverse order of removal.
Adjustment
INFOID:0000000009721821
Adjust the guide line position if the guide line position is shifted after installing the rear view camera.
1.
Rear view camera
2.
Finisher
JPNIA0797ZZ
AV
REAR VIEW CAMERA
AV-291
< REMOVAL AND INSTALLATION >
[BOSE AUDIO WITHOUT NAVIGATION]
C
D
E
F
G
H
I
J
K
L
M
B
A
O
P
1.
Draw lines on rearward area of the vehicle passing through the
following points: 200 mm (7.87 in) from both sides of the vehicle,
and 0.5 m (1.64 ft), 1.0 m (3.28 ft) from the rear end of the
bumper.
2.
Set into “Adjust Guide Lines” mode of “Confirmation/Adjust-
ment” mode.
3.
Rotate the center dial, and then select the guiding line pattern so
that its angle is aligned with the correction line of the rear of the
vehicle.
4.
Make fine adjustment to the correction line of the rear of the
vehicle with up/down/left/right switches so that its position is
aligned with the guiding line. Press “OK” switch and record the
adjusted guiding line position to the AV control unit.
CAUTION:
Never operate other function such as pressing BACK while writing index data.
SKIB3691E
Selected pattern
: 7
Up/Down adjustment range
: 20
°
to 20
°
Left/Right adjustment range
: 20
°
to 20
°
JSNIA2231ZZ
AV-292
< REMOVAL AND INSTALLATION >
[BOSE AUDIO WITHOUT NAVIGATION]
STEERING ANGLE SENSOR
STEERING ANGLE SENSOR
Exploded View
INFOID:0000000009721822
DISASSEMBLY
Removal and Installation
INFOID:0000000009721823
REMOVAL
1.
Remove spiral cable. Refer to
(except for Mexico) or
(for
Mexico).
2.
Remove steering angle sensor from spiral cable.
INSTALLATION
1.
Install in the reverse order of removal.
2.
Perform steering angle sensor neutral position adjustment. Refer to
JSNIA0135ZZ
1.
Spiral cable
2.
Steering angle sensor
AV
TEL ADAPTER UNIT
AV-293
< REMOVAL AND INSTALLATION >
[BOSE AUDIO WITHOUT NAVIGATION]
C
D
E
F
G
H
I
J
K
L
M
B
A
O
P
TEL ADAPTER UNIT
Exploded View
INFOID:0000000009721824
Removal and Installation
INFOID:0000000009721825
REMOVAL
1.
Remove luggage floor finisher front. Refer to
2.
Remove TEL adapter unit (1) with satellite radio tuner as a sin-
gle unit from the vehicle.
3.
Remove bracket screws, and them remove TEL adapter unit.
INSTALLATION
Install in the reverse order of removal.
1.
Satellite radio tuner
2.
Bracket LH
3.
TEL adapter unit
4.
Bracket RH
JPNIA0784ZZ
JPNIA0805ZZ
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст