Nissan Murano. Instruction — part 1009
MIR-14
< DTC/CIRCUIT DIAGNOSIS >
[WITH ADP]
DOOR MIRROR REMOTE CONTROL SWITCH
1.
Turn ignition switch OFF.
2.
Disconnect automatic drive positioner control unit connector.
3.
Check continuity between automatic drive positioner control unit harness connector and door mirror
remote control switch harness connector.
4.
Check continuity between automatic drive positioner control unit harness connector and ground.
Is the inspection result normal?
YES
>> Replace automatic drive positioner control unit. Refer to
ADP-211, "Removal and Installation"
.
NO
>> Repair or replace harness.
3.
CHECK DOOR MIRROR REMOTE CONTROL SWITCH GROUND CIRCUIT
1.
Turn ignition switch OFF.
2.
Check continuity between door mirror remote control switch harness connector and ground.
Is the inspection result normal?
YES
>> GO TO 4.
NO
>> Repair or replace harness.
4.
CHECK CHANGEOVER SWITCH
Check door mirror remote control switch (changeover switch).
Refer to
MIR-14, "CHANGEOVER SWITCH : Component Inspection"
Is the inspection result normal?
YES
>> GO TO 5.
NO
>> Replace door mirror remote control switch (changeover switch). Refer to
5.
CHECK INTERMITTENT INCIDENT
Check intermittent incident.
Refer to
GI-44, "Intermittent Incident"
>> INSPECTION END
CHANGEOVER SWITCH : Component Inspection
INFOID:0000000009719329
1.
CHECK CHANGEOVER SWITCH
1.
Turn ignition switch OFF.
2.
Disconnect door mirror remote control switch connector.
3.
Check continuity between door mirror remote control switch terminals.
Automatic drive positioner control unit Door
mirror
remote control switch
Continuity
Connector
Terminal
Connector
Terminal
M75
2
D14
11
Existed
14
10
Automatic drive positioner control unit
Ground
Continuity
Connector
Terminal
M75
2
Not existed
14
Door mirror remote control switch
Ground
Continuity
Connector
Terminal
D14
7
Existed
DOOR MIRROR REMOTE CONTROL SWITCH
MIR-15
< DTC/CIRCUIT DIAGNOSIS >
[WITH ADP]
C
D
E
F
G
H
I
J
K
M
A
B
MIR
N
O
P
Is the inspection result normal?
YES
>> INSPECTION END
NO
>> Replace door mirror remote control switch. Refer to
MIR-75, "Removal and Installation"
Door mirror remote control switch
Condition
Continuity
Connector
Terminal
D14
10
7
Changeover switch
LEFT
Existed
Other than above
Not existed
11
RIGHT
Existed
Other than above
Not existed
MIR-16
< DTC/CIRCUIT DIAGNOSIS >
[WITH ADP]
DOOR MIRROR
DOOR MIRROR
Wiring Diagram - DOOR MIRROR SYSTEM (WITH AUTOMATIC DRIVE POSITION-
ER) -
INFOID:0000000009719330
JCLWM2736GB
DOOR MIRROR
MIR-17
< DTC/CIRCUIT DIAGNOSIS >
[WITH ADP]
C
D
E
F
G
H
I
J
K
M
A
B
MIR
N
O
P
JRLWC9403GB
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст