Nissan Murano. Instruction — part 1434
VTL-92
< REMOVAL AND INSTALLATION >
[WITH 7 INCH DISPLAY]
SUNLOAD SENSOR
SUNLOAD SENSOR
Exploded View
INFOID:0000000009721165
Removal and Installation
INFOID:0000000009721166
REMOVAL
Disconnect sunload sensor connector and then remove sunload
sensor (1).
INSTALLATION
Install in the reverse order of removal.
1.
Sunload sensor
JPIIA0559ZZ
JPIIA0560ZZ
INTAKE SENSOR
VTL-93
< REMOVAL AND INSTALLATION >
[WITH 7 INCH DISPLAY]
C
D
E
F
G
H
J
K
L
M
A
B
VTL
N
O
P
INTAKE SENSOR
Exploded View
INFOID:0000000009721167
Removal and Installation
INFOID:0000000009721168
REMOVAL
1.
Remove evaporator pipe assembly. Refer to
2.
Slide the evaporator (1) toward the right side of the vehicle and
then remove intake sensor (2).
INSTALLATION
Note the following items, and then install in the reverse order of removal.
CAUTION:
• Replace the O-ring with a new one. Apply a coat of compressor oil to the O-ring prior to installation.
• Install the intake sensor in the same position as the removed intake sensor when replacing the
intake sensor.
• Never rotate the bracket insertion part when removing and installing the intake sensor.
• Check for refrigerant leakage when charging refrigerant.
1.
Heater & cooling unit assembly
2.
Intake sensor bracket
3.
Intake sensor
4.
Evaporator assembly
5.
Evaporator cover
6.
Air mix door motor (Passenger side)
7.
Foot duct RH
8.
Cooler pipe grommet
JPIIA1303ZZ
JPIIA0907ZZ
VTL-94
< REMOVAL AND INSTALLATION >
[WITH 7 INCH DISPLAY]
BLOWER UNIT
BLOWER UNIT
Exploded View
INFOID:0000000009721169
REMOVAL
DISASSEMBLY
1.
Blower unit assembly
2.
Heater & cooling unit assembly
3.
Steering member
4.
Instrument stay
5.
Instrument panel assembly
: N·m (kg-m, ft-lb)
: N·m (kg-m, in-lb)
JSIIA1794GB
BLOWER UNIT
VTL-95
< REMOVAL AND INSTALLATION >
[WITH 7 INCH DISPLAY]
C
D
E
F
G
H
J
K
L
M
A
B
VTL
N
O
P
Removal and Installation
INFOID:0000000009721170
REMOVAL
1.
Remove instrument panel assembly. Refer to
.
2.
Remove mounting nuts (A) and then remove instrument panel
stay (1).
3.
Disconnect intake door motor and blower motor connectors.
4.
Remove heater & cooling unit assembly and blower unit mounting bolts (A).
1.
Shutter box case
2.
Intake door
3.
Intake door motor
4.
Blower motor assembly
5.
Intake lower case
6.
Outlet seal
7.
Intake seal
8.
Intake upper case
JPIIA0455ZZ
JPIIA0565ZZ
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст