Nissan Murano. Instruction — part 313
DAS-142
< WIRING DIAGRAM >
[BSW]
DRIVER ASSISTANCE SYSTEMS
JROWC1669GB
DAS
DIAGNOSIS AND REPAIR WORK FLOW
DAS-143
< BASIC INSPECTION >
[BSW]
C
D
E
F
G
H
I
J
K
L
M
B
N
P
A
BASIC INSPECTION
DIAGNOSIS AND REPAIR WORK FLOW
Work Flow
INFOID:0000000009723332
OVERALL SEQUENCE
DETAILED FLOW
1.
INTERVIEW FOR MALFUNCTION
It is also important to clarify the customer concerns before starting the inspection. Interview the customer
about the concerns carefully and understand the symptoms fully.
NOTE:
JSOIA0654GB
DAS-144
< BASIC INSPECTION >
[BSW]
DIAGNOSIS AND REPAIR WORK FLOW
The customers are not professionals. Never assume that “maybe the customer means···” or “maybe the cus-
tomer mentioned this symptom”.
>> GO TO 2.
2.
SELF-DIAGNOSIS WITH CONSULT
1.
Perform “All DTC Reading” with CONSULT.
2.
Check if the DTC is detected on the self-diagnosis results of “AVM”.
3.
When DTC is detected, follow the instructions below:
-
Record DTC and Freeze Frame Data.
Is any DTC detected?
YES
>> GO TO 5.
NO
>> GO TO 3.
3.
PRE-INSPECTION FOR DIAGNOSIS
Perform pre-inspection for diagnosis. Refer to
DAS-145, "Inspection Procedure"
.
>> GO TO 4.
4.
ACTION TEST
Perform BSW system action test to check the operation status. Refer to
Check if any other malfunctions occur.
>> GO TO 6.
5.
TROUBLE DIAGNOSIS BY DTC
1.
Check the DTC in the self-diagnosis results.
2.
Perform trouble diagnosis for the detected DTC. Specify a malfunctioning part. Refer to
(AVM).
>> GO TO 8.
6.
SYMPTOM DIAGNOSIS
Perform the applicable diagnosis according to the diagnosis chart by symptom. Refer to
.
>> GO TO 7.
7.
MALFUNCTIONING PART REPAIR
Repair or replace the identified malfunctioning parts.
>> GO TO 8.
8.
REPAIR CHECK (SELF-DIAGNOSIS WITH CONSULT)
1.
Erases self-diagnosis results.
2.
Perform “All DTC Reading” again after repairing or replacing the specific items.
3.
Check if any DTC is detected in self-diagnosis results of “AVM”.
Is any DTC detected?
YES
>> GO TO 5.
NO
>> GO TO 9.
9.
REPAIR CHECK (ACTION TEST)
Perform the BSW system action test. Check that the malfunction symptom is solved or no other symptoms
occur.
Is there a malfunction symptom?
YES
>> GO TO 4.
NO
>> INSPECTION END
DAS
PRE-INSPECTION FOR DIAGNOSIS
DAS-145
< BASIC INSPECTION >
[BSW]
C
D
E
F
G
H
I
J
K
L
M
B
N
P
A
PRE-INSPECTION FOR DIAGNOSIS
Inspection Procedure
INFOID:0000000009723333
1.
CHECK REAR VIEW CAMERA LENS
Are rear view camera lens contaminated with foreign materials?
YES
>> Clean rear view camera lens.
NO
>> GO TO 2.
2.
CHECK REAR VIEW CAMERA INSTALLATION CONDITION
Check rear view camera installation condition (e.g. position, looseness, bent in back door).
Is it properly installed?
YES
>> INSPECTION END
NO
>> Install rear view camera properly, and perform rear view camera calibration. Refer to
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст