Nissan Murano. Instruction — part 124
AV-274
< SYMPTOM DIAGNOSIS >
[BOSE AUDIO WITHOUT NAVIGATION]
NORMAL OPERATING CONDITION
Noise resulting from variations in field strength, such as fading noise and multi-path noise, or external noise from trains and other
sources, is not a malfunction.
NOTE:
• Fading noise: This noise occurs because of variations in the field strength in a narrow range due to mountains or buildings blocking
the signal.
• Multi-path noise: This noise results from a time difference between the broadcast waves directly from the station arriving at the
antenna and the waves reflected by mountains or buildings.
RELATED TO HANDS-FREE PHONE
Symptom
Cause and Counter measure
Cannot play
Check if the CD was inserted correctly.
Check if the CD is scratched or dirty.
Check if there is condensation inside the player, and if there is, wait until the condensation is gone
(about 1 hour) before using the player.
If there is a temperature increase error, the player will play correctly after it returns to the normal
temperature.
If there is a mixture of music CD files (CD-DA data) and MP3/WMA files on a CD, only the music
CD files (CD-DA data) will be played.
Files with extensions other than “.MP3 (.mp3)” or “.WMA (.wma)” cannot be played. In addition,
the character codes and number of characters for folder names and file names should be in com-
pliance with the specifications.
Check if the disc or the file is generated in an irregular format, This may occur depending on the
variation or the setting of MP3/WMA writing applications or other text editing applications.
Check if the finalization process, such as session close and disc close, is done for the disc.
Check if the CD is protected by copyright.
Disks recorded in live file system format are not supported. (For Microsoft Windows Vista, check
the settings.)
Poor sound quality
Check if the CD is scratched or dirty.
It takes a relatively long time before
the music starts playing.
If there are many folder or file levels on the MP3/WMA CD, or if it is a multisession disc, some
time may be required before the music starts playing.
Music cuts off or skips
The writing software and hardware combination might not match, or the writing speed, writing
depth, writing width might not match the specifications. Try using the slowest writing speed.
Skipping with high bit rate files
Skipping may occur with large quantities if data such as for high bit rate data.
Move immediately to the next song
when playing
When a non-MP3/WMA file has been given an extension of “.MP3 (.mp3)” or “.WMA (.wma)”
when play is prohibited by copyright protection, the player will skip to the next song.
The songs do not play back in the
desired order.
The playback order is the order in which the files were written by the software, so the files might
not play in the desired order.
Poor reception only from a certain
radio broadcast station.
Check incoming radio wave signal strength of applicable broadcast station.
Buzz/rattle sound from speaker
The majority of rattle sounds are not indicative of an issue with the speaker, usually something
nearby the speaker is causing the rattle.
AV
NORMAL OPERATING CONDITION
AV-275
< SYMPTOM DIAGNOSIS >
[BOSE AUDIO WITHOUT NAVIGATION]
C
D
E
F
G
H
I
J
K
L
M
B
A
O
P
Symptom
Cause and Counter measure
Does not recognize cellular phone connection. (No connection is
displayed on the display at the guide.)
Some Bluetooth
®
enabled cellular phones may not be recognized
by the in-vehicle phone module. Refer to “RELATED TO HANDS-
FREE PHONE (Check Compatibility)” of MULTI AV SYSTEM
SYMPTOM.
Cannot use hands-free phone
Customer will not be able to use a hands-free phone under the fol-
lowing conditions.
• The vehicle is outside of the telephone service area.
• The vehicle is in an area where it is difficult to receive radio
waves; such as in a tunnel, in an underground parking garage,
near a tall building or in a mountainous area.
• The cellular phone is locked to prevent it from being dialed.
NOTE:
While a cellular phone is connected through the Bluetooth
®
wire-
less connection, the battery power of the cellular phone may dis-
charge quicker than usual. The Bluetooth
®
Hands-Free Phone
System cannot charge cellular phones.
The other party's voice cannot be heard by hands-free phone.
When the radio wave condition is not ideal or ambient sound is too
loud, it may be difficult to hear the other person's voice during a
call.
Poor sound quality
Do not place the cellular phone in an area surrounded by metal or
far away from the in-vehicle phone module to prevent tone quality
degradation and wireless connection disruption.
AV-276
< REMOVAL AND INSTALLATION >
[BOSE AUDIO WITHOUT NAVIGATION]
AV CONTROL UNIT
REMOVAL AND INSTALLATION
AV CONTROL UNIT
Exploded View
INFOID:0000000009721793
CAUTION:
Before replacing AV control unit, perform “Read/Write Configuration” to save or print current vehicle
specification. For details, refer to
.
REMOVAL
.
DISASSEMBLY
Removal and Installation
INFOID:0000000009721794
REMOVAL
CAUTION:
Before replacing AV control unit, perform “Read/Write Configuration” to save or print current vehicle
specification. For details, refer to
.
1.
Remove cluster lid C. Refer to
2.
Remove AV control unit with an A/C auto amp. as a single unit from the vehicle.
3.
Remove bracket screws, and then remove AV control unit.
INSTALLATION
Install in the reverse order of removal.
CAUTION:
Be sure to perform “Read/Write Configuration” when replacing AV control unit. For details, refer to
.
1.
AV control unit
2.
Bracket LH
3.
A/C auto amp.
4.
Bracket RH
JSNIA1740ZZ
AV
DISPLAY UNIT
AV-277
< REMOVAL AND INSTALLATION >
[BOSE AUDIO WITHOUT NAVIGATION]
C
D
E
F
G
H
I
J
K
L
M
B
A
O
P
DISPLAY UNIT
Exploded View
INFOID:0000000009721795
Removal and Installation
INFOID:0000000009721796
REMOVAL
1.
Remove center ventilator assembly. Refer to
2.
Remove display unit with bracket as a single unit.
INSTALLATION
Install in the reverse order of removal.
JPNIA0779ZZ
1.
Display unit
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст