Nissan Murano. Instruction — part 768
FL-12
< REMOVAL AND INSTALLATION >
FUEL TANK
4.
Remove parking rear brake cables. Refer to
.
5.
Remove rear suspension member assembly. Refer to
. (AWD models)
NOTE:
For this service, drive shaft, final drive, and rear suspension member are required not to be separate one
another during removal.
6.
Remove fuel tank protectors.
7.
Disconnect fuel filler hose (1), EVAP/Vent line hose (3), and
EVAP (Recirculation) hose (2) from the side other than the fuel
tank side.
8.
Support the lower part of fuel tank (1) with transmission jack (A).
CAUTION:
Support the position that fuel tank mounting bands never
engage.
9.
Remove fuel tank mounting bands.
10. Supporting with hands, descend transmission jack carefully, and remove fuel tank.
CAUTION:
• Check that all connection points have been disconnected.
• Confirm there is no interference with vehicle.
11. Remove fuel filler tube if necessary.
INSTALLATION
Note the following, and install in the reverse order of removal.
• Surely clamp fuel hoses and insert hose to the length below.
• Be sure hose clamp is not placed on swelled area of fuel tube.
• Tighten the clamp hand with the top mark (A) until the mark is on
the bolt head flange.
• To connect quick connector, refer to
FL-6, "Removal and Installation"
.
: Vehicle front
JPBIA1696ZZ
JPBIA0145ZZ
Fuel filler hose
: 35 mm (1.38 in)
The other hoses
: 25 mm (0.98 in)
JPBIA0146ZZ
FUEL TANK
FL-13
< REMOVAL AND INSTALLATION >
C
D
E
F
G
H
I
J
K
L
M
A
FL
N
P
O
Inspection
INFOID:0000000009720461
INSPECTION AFTER INSTALLATION
Use the following procedure to check for fuel leakage.
1.
Turn ignition switch “ON” (with engine stopped), and check connections for leakage by applying fuel pres-
sure to fuel piping.
2.
Start engine and rev it up and check there are no fuel leakage at the fuel system tube and hose connec-
tions.
• After removing/installing rear suspension assembly, check to adjust wheel alignment and then, adjust neutral
position of steering angle sensor. Refer to
BRC-9, "ADJUSTMENT OF STEERING
FL-14
< REMOVAL AND INSTALLATION >
EVAP CANISTER
EVAP CANISTER
Hydraulic Layout
INFOID:0000000010112353
EVAPORATIVE EMISSION LINE DRAWING
1.
Intake manifold collector
2.
EVAP canister purge volume control
solenoid valve
3.
EVAP service port
A.
From EVAP canister
: Vehicle front
ALBIA0106ZZ
EVAP CANISTER
FL-15
< REMOVAL AND INSTALLATION >
C
D
E
F
G
H
I
J
K
L
M
A
FL
N
P
O
NOTE:
Do not use soapy water or any type of solvent while installing vacuum hose or purge hoses.
1.
EVAP control system pressure sen-
sor
2.
EVAP canister vent control valve
3.
EVAP canister
A.
To previous figure
B.
To/From B in this figure
C.
Refer to previous figure
: Vehicle front
JMBIA1122ZZ
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст