Nissan Murano. Instruction — part 277
WATER OUTLET AND WATER PIPING
CO-29
< REMOVAL AND INSTALLATION >
C
D
E
F
G
H
I
J
K
L
M
A
CO
N
P
O
WATER OUTLET AND WATER PIPING
Exploded View
INFOID:0000000009720495
Removal and Installation
INFOID:0000000009720496
REMOVAL
1.
Remove air duct (inlet), radiator core support covers (RH and LH), air cleaner cases (upper and lower)
with mass air flow sensor and air duct assembly. Refer to
2.
Remove engine cover. Refer to
.
3.
Drain engine coolant from radiator drain plug at the bottom of radiator, and from water drain plug at the
front of cylinder block. Refer to
CAUTION:
1.
Heater hose
2.
Clamp
3.
Water hose
4.
Clamp
5.
Water outlet
6.
Gasket
7.
Gasket
8.
Water connector
9.
O-ring
10. Water bypass pipe
11.
Clamp
12.
Water hose
13. Heater pipe
14.
Water hose
15.
Heater hose
16. Engine coolant temperature sensor
17.
Clamp
18.
Radiator hose (upper)
A.
To heater core
B.
To electric throttle control actuator
C.
To oil cooler
D.
To radiator
: Always replace after every disassembly.
: N·m (kg-m, ft-lb)
: N·m (kg-m, in-lb)
JPBIA1691GB
CO-30
< REMOVAL AND INSTALLATION >
WATER OUTLET AND WATER PIPING
• Perform this step when the engine is cold.
• Never spill engine coolant on drive belt.
4.
Remove battery and battery tray. Refer to
PG-97, "Removal and Installation"
.
5.
Remove CVT fluid charging pipe and CVT fluid level gauge. Refer to
6.
Move CVT control cable aside. Refer to
7.
Remove vacuum tube (front) mounting bolt from water outlet. Refer to
(2WD models) or
(AWD models).
8.
Remove radiator hose (upper) from water outlet.
9.
Remove water hoses and heater hoses.
10. Disconnect harness connectors, and move harness to aside.
11. Remove engine coolant temperature sensor if necessary.
CAUTION:
Be careful not to damage engine coolant temperature sensor.
12. Remove water outlet, heater pipe, water bypass pipe and water connector.
INSTALLATION
CAUTION:
Do not reuse O-rings.
Note the following, and install in the reverse order of removal.
• Securely insert each hose, and install clamp at a position where it does not interfere with the pipe bulge.
• When inserting water bypass pipe and heater pipe into water connector, apply neutral detergent to O-ring.
Inspection
INFOID:0000000009720497
INSPECTION AFTER INSTALLATION
• Check for leakage of engine coolant using the radiator cap tester adapter (commercial service tool) and the
radiator cap tester (commercial service tool). Refer to
• Start and warm up the engine. Visually check that there is no leakage of engine coolant.
SERVICE DATA AND SPECIFICATIONS (SDS)
CO-31
< SERVICE DATA AND SPECIFICATIONS (SDS)
C
D
E
F
G
H
I
J
K
L
M
A
CO
N
P
O
SERVICE DATA AND SPECIFICATIONS (SDS)
SERVICE DATA AND SPECIFICATIONS (SDS)
Periodical Maintenance Specification
INFOID:0000000009720498
ENGINE COOLANT CAPACITY (APPROXIMATE)
Unit:
(US qt, lmp qt)
Radiator
INFOID:0000000009720499
Unit: kPa (kg/cm
2
, psi)
Thermostat
INFOID:0000000009720500
Standard
Engine coolant capacity (With reservoir tank at “MAX” level)
9.0 (9-1/2, 7-7/8)
Reservoir tank
0.8 (7/8, 3/4)
Cap relief pressure
Standard
122.3 - 151.7 (1.2 - 1.5, 17.7 - 22.0)
Limit
108 (1.1, 15.6)
Leakage test pressure
156 (1.59, 22.6)
Valve opening temperature
80.5 - 83.5
°
C (177 - 182
°
F)
Maximum valve lift
8.6 mm/95
°
C (0.339 in/203
°
F)
Valve closing temperature
77
°
C (171
°
F)
DAS-1
CRUISE CONTROL
& DRIVER ASSISTANCE
C
D
E
F
G
H
I
J
K
L
M
B
DAS
SECTION
DAS
N
P
A
CONTENTS
DRIVER ASSISTANCE SYSTEM
LDW
PRECAUTION . . . . . . . . . . . ...
PRECAUTIONS . . . . . . . . . . . . ...
FOR USA AND CANADA . . . . . . . . . . ....
FOR USA AND CANADA : Precautions for Re-
moving of Battery Terminal . . . . . . . . . ...
FOR USA AND CANADA : Precaution for LDW
System Service . . . . . . . . . . . . . .....
FOR MEXICO . . . . . . . . . . . . . . . ..
FOR MEXICO : Precautions for Removing of Bat-
tery Terminal . . . . . . . . . . . . . . .....
FOR MEXICO : Precaution for LDW System Ser-
vice . . . . . . . . . . . . . . . . . . ....
SYSTEM DESCRIPTION . . . . . . . ..
COMPONENT PARTS . . . . . . . . . .
Component Parts Location . . . . . . . . . ....
Camera Control Unit . . . . . . . . . . . .....
Combination Meter . . . . . . . . . . . . ....
Rear View Camera . . . . . . . . . . . . ....
Pump Control Unit . . . . . . . . . . . . ...
Air Pump . . . . . . . . . . . . . . . . .
Washer Switching Solenoid Valve . . . . . . ..
Rear View Camera Washer Relay . . . . . . ..
Warning Systems Switch/Warning Systems ON
Indicator . . . . . . . . . . . . . . . . ..
SYSTEM . . . . . . . . . . . . . . . .
System Description . . . . . . . . . . . . .
Fail-Safe . . . . . . . . . . . . . . . . ..
OPERATION . . . . . . . . . . . . . .
Switch Name and Function . . . . . . . . . ..
System Display and Warning . . . . . . . . ..
HANDLING PRECAUTION . . . . . . . ...
Precautions for Lane Departure Warning . . . .
DIAGNOSIS SYSTEM (CAMERA CONTROL
UNIT) . . . . . . . . . . . . . . . . .
CONSULT Function . . . . . . . . . . . . .
ECU DIAGNOSIS INFORMATION . . . ..
CAMERA CONTROL UNIT . . . . . . . ...
Reference Value . . . . . . . . . . . . . ..
Fail-Safe . . . . . . . . . . . . . . . . ..
DTC Inspection Priority Chart . . . . . . . . ..
DTC Index . . . . . . . . . . . . . . . ...
PUMP CONTROL UNIT . . . . . . . . .
Reference Value . . . . . . . . . . . . . ..
WIRING DIAGRAM . . . . . . . . . ..
DRIVER ASSISTANCE SYSTEMS . . . . ...
Wiring Diagram . . . . . . . . . . . . . .
BASIC INSPECTION . . . . . . . . ...
DIAGNOSIS AND REPAIR WORK FLOW . ...
Work Flow . . . . . . . . . . . . . . . .
PRE-INSPECTION FOR DIAGNOSIS . . . ..
Inspection Procedure . . . . . . . . . . . ...
REAR VIEW CAMERA WASHER/AIR BLOW-
ER FUNCTION INSPECTION . . . . . . ...
Inspection Procedure . . . . . . . . . . . ...
ACTION TEST . . . . . . . . . . . . ...
Description . . . . . . . . . . . . . . . ...
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст