Nissan Murano. Instruction — part 813
HAC-26
< SYSTEM DESCRIPTION >
[WITHOUT 7 INCH DISPLAY]
AUTOMATIC AIR CONDITIONER SYSTEM
1.
Intake door motor
2.
Upper ventilator door motor
3.
Air mix door motor (passenger side)
4.
Air mix door motor (driver side)
5.
Mode door motor
6.
Sunload sensor
7.
In-vehicle sensor
8.
A/C auto amp.
9.
Intake sensor
10. Blower motor
JPIIA0608ZZ
AUTOMATIC AIR CONDITIONER SYSTEM
HAC-27
< SYSTEM DESCRIPTION >
[WITHOUT 7 INCH DISPLAY]
C
D
E
F
G
H
J
K
L
M
A
B
HAC
N
O
P
Component Description
INFOID:0000000009722036
Component
Reference
Refrigerant pressure sensor
Compressor
Ambient sensor
Intake door motor
Upper ventilator door motor
Air mix door motor (driver side)
Air mix door motor (passenger side)
Mode door motor
Sunload sensor
In-vehicle sensor
A/C auto amp.
HAC-77, "A/C AUTO AMP. : Description"
Intake sensor
Blower motor
HAC-28
< SYSTEM DESCRIPTION >
[WITHOUT 7 INCH DISPLAY]
MODE DOOR CONTROL SYSTEM
MODE DOOR CONTROL SYSTEM
System Diagram
INFOID:0000000009722037
System Description
INFOID:0000000009722038
The mode door is automatically controlled by the temperature setting, ambient temperature, in-vehicle temper-
ature, intake temperature and amount of sunload.
SYSTEM OPERATION
• The A/C auto amp. receives data from each of the sensors.
• The A/C auto amp. sends the air mix door, the mode door, the upper ventilator door and the intake door
opening angle data to the air mix door motor LCU(s), the mode door motor LCU, the upper ventilator door
motor LCU and the intake door motor LCU.
• The air mix door motor(s), the mode door motor, the upper ventilator door motor and the intake door motor
read their respective signals according to the address signal. Opening angle indication signals received from
the A/C auto amp. and each of the motor position sensors are compared by the LCUs in each door motor
with the existing decision and opening angles.
• Next, HOT/COLD, DEF/VENT, OPEN/SHUT or FRE/REC operations is selected. The newly selected data is
returned to the A/C auto amp.
Door Motor Circuit
Mode Door Control Specification
JMIIA0491GB
JPIIA0495GB
MODE DOOR CONTROL SYSTEM
HAC-29
< SYSTEM DESCRIPTION >
[WITHOUT 7 INCH DISPLAY]
C
D
E
F
G
H
J
K
L
M
A
B
HAC
N
O
P
Mode position can be selected instructionly by pressing the MODE
switch or the DEF switch on the A/C control. This enables to fix a
mode position. Pressing the AUTO switch allows automatic control
by the A/C auto amp. During the automatic control of a mode posi-
tion, a mode door position (VENT, B/L, FOOT, or D/F) is selected
based on a target the air mix door opening angle and sunload
depending on the temperature calculated by the A/C auto amp. In
addition, the D/F is selected to prevent windshield fogging only when
ambient temperature is extremely low with mode position the FOOT.
JPIIA0767GB
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст