Nissan Murano. Instruction — part 301
DAS-94
< REMOVAL AND INSTALLATION >
[LDW]
CAMERA CONTROL UNIT
REMOVAL AND INSTALLATION
CAMERA CONTROL UNIT
Exploded View
INFOID:0000000009723294
Removal and Installation
INFOID:0000000009723295
REMOVAL
CAUTION:
Before replacing camera control unit, perform “Read/Write Configuration” to save or print current
vehicle specification. For details, refer to
1.
Remove luggage side finisher lower (RH). Refer to
INT-35, "Removal and Installation"
2.
Disengage air tube clip from camera control unit bracket.
3.
Remove camera control unit screws, disconnect camera control unit connector and remove the camera
control unit.
INSTALLATION
Install in the reverse order of removal.
CAUTION:
Must be perform additional service when replacing camera control unit. Refer to
Camera control unit
JPNIA0796ZZ
DAS
REAR VIEW CAMERA
DAS-95
< REMOVAL AND INSTALLATION >
[LDW]
C
D
E
F
G
H
I
J
K
L
M
B
N
P
A
REAR VIEW CAMERA
Exploded View
INFOID:0000000009723296
Removal and Installation
INFOID:0000000009723297
REMOVAL
1.
Remove back door finisher inner. Refer to
INT-38, "Removal and Installation"
2.
Remove finisher.
3.
Disconnect air tube and washer tube from rear view camera.
4.
Remove rear view camera mounting screws, disconnect rear view camera connector and remove rear
view camera from back door assembly.
CAUTION:
To prevent a malfunction resulting from a short circuit, never allow washer fluid to drip from tube
to rear view camera and connector.
INSTALLATION
Install in the reverse order of removal.
Rear view camera
Finisher
JSOIA0656ZZ
DAS-96
< REMOVAL AND INSTALLATION >
[LDW]
PUMP CONTROL UNIT
PUMP CONTROL UNIT
Exploded View
INFOID:0000000009723298
Removal and Installation
INFOID:0000000009723299
REMOVAL
1.
Remove luggage floor front finisher. Refer to
INT-35, "Removal and Installation"
.
2.
Remove luggage mask. Refer to
.
3.
Remove pump control unit mounting screws, disconnect pump control unit harness connector and remove
pump control unit.
INSTALLATION
Install in the reverse order of removal.
Luggage trim bracket
Pomp control unit
: Vehicle front
JSOIA0661ZZ
DAS
AIR PUMP
DAS-97
< REMOVAL AND INSTALLATION >
[LDW]
C
D
E
F
G
H
I
J
K
L
M
B
N
P
A
AIR PUMP
Exploded View
INFOID:0000000009723300
Removal and Installation
INFOID:0000000009723301
REMOVAL
1.
Remove luggage floor spacer LH. Refer to
INT-35, "Removal and Installation"
2.
Disconnect air tube and air pump harness connector.
3.
Remove air pump cover bolts and nut and remove air pump cover.
4.
Remove air pump from luggage floor spacer LH.
INSTALLATION
Note the following items, and then install in the reverse order of removal.
CAUTION:
Remove double-sided tape remaining on luggage floor spacer LH with a double-sided tape remover,
after removing air pump.
Air pump cover
Air pump
Luggage floor spacer LH
: Vehicle front
: Always replace after every disassembly.
: N·m (kg-m, in-lb)
JSOIA0662ZZ
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст