Nissan Murano. Instruction — part 1230
NISSAN VEHICLE IMMOBILIZER SYSTEM-NATS
SEC-17
< SYSTEM DESCRIPTION >
[WITH INTELLIGENT KEY SYSTEM]
C
D
E
F
G
H
I
J
L
M
A
B
SEC
N
O
P
Component Description
INFOID:0000000009722703
A.
Behind the combination meter
B.
Engine room (LH)
C.
View with the center console as-
sembly removed
D.
Behind the instrument lower panel LH
E.
Behind the instrument lower panel RH
1.
Front power window switch (passen-
ger side)
2.
Inside key antenna (console)
3.
Inside key antenna (luggage room)
4.
Back door lock assembly (back door
switch)
5.
Front door switch (driver side)
6.
power window main switch (door
lock and unlock switch)
A.
Under the rear seat seatback
JMKIA4874ZZ
Component Reference
BCM
Push-button ignition switch
Door switch
key slot
CVT shift selector (detention switch)
Inside key antenna
Remote keyless entry receiver
Stop lamp switch
Transmission range switch
Starter relay
Starter control relay
SEC-18
< SYSTEM DESCRIPTION >
[WITH INTELLIGENT KEY SYSTEM]
NISSAN VEHICLE IMMOBILIZER SYSTEM-NATS
Security indicator lamp
Key warning lamp
Component Reference
VEHICLE SECURITY SYSTEM
SEC-19
< SYSTEM DESCRIPTION >
[WITH INTELLIGENT KEY SYSTEM]
C
D
E
F
G
H
I
J
L
M
A
B
SEC
N
O
P
VEHICLE SECURITY SYSTEM
System Diagram
INFOID:0000000009722704
System Description
INFOID:0000000009722705
OPERATION FLOW
SETTING THE VEHICLE SECURITY SYSTEM
Initial Condition
• Ignition switch is in OFF position.
Disarmed Phase
• When any door or back door is open, the vehicle security system is set in the disarmed phase on the
assumption that the owner is inside or near the vehicle.
JMKIA3709GB
JMKIA2505GB
SEC-20
< SYSTEM DESCRIPTION >
[WITH INTELLIGENT KEY SYSTEM]
VEHICLE SECURITY SYSTEM
• When the vehicle security system is in the disarmed phase, the security indicator lamp blinks every 2.4 sec-
onds.
Pre-armed Phase and Armed Phase
When the following operation is performed, the vehicle security system turns into the “pre-armed” phase. (The
security indicator lamp illuminates.)
1.
BCM receives LOCK signal from front door request switch, Intelligent Key or door key cylinder, after back
door and all doors are closed.
2.
Security indicator lamp illuminates for 30 seconds. Then, the system automatically shifts into the “armed”
phase.
CANCELING THE SET VEHICLE SECURITY SYSTEM
When one of the following operations is performed, the armed phase is canceled.
1.
Unlock the all doors with the door request switch, Intelligent Key or door key cylinder.
2.
Turn ignition switch “ON” or “ACC” position.
CANCELING THE ALARM OPERATION OF THE VEHICLE SECURITY SYSTEM
When unlocking the all doors with the door request switch, Intelligent Key or door key cylinder switch the alarm
operation is canceled.
ACTIVATING THE ALARM OPERATION OF THE VEHICLE SECURITY SYSTEM
Check that the system is in the armed phase. (The security indicator lamp blinks every 2.4 seconds.)
When the following operation 1 or 2 is performed, the system sounds the horns and flashes the headlamps for
about 50 seconds.
1.
Back door or any door is opened during armed phase.
2.
Disconnecting and connecting the battery connector before canceling armed phase.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст