Nissan GT-R. Instruction — part 64
CHG
PRECAUTIONS
CHG-11
< PRECAUTION >
C
D
E
F
G
H
I
J
K
L
B
A
O
P
N
NOTE:
Supply power using jumper cables if battery is discharged.
2.
Turn the ignition switch to ACC position.
(At this time, the steering lock will be released.)
3.
Disconnect both battery cables. The steering lock will remain released with both battery cables discon-
nected and the steering wheel can be turned.
4.
Perform the necessary repair operation.
5.
When the repair work is completed, re-connect both battery cables. With the brake pedal released, turn
the ignition switch from ACC position to ON position, then to LOCK position. (The steering wheel will lock
when the ignition switch is turned to LOCK position.)
6.
Perform self-diagnosis check of all control units using CONSULT.
Precaution for Battery Service
INFOID:0000000009160058
Before disconnecting the battery, lower both the driver and passenger windows. This will prevent any interfer-
ence between the window edge and the vehicle when the door is opened/closed. During normal operation, the
window slightly raises and lowers automatically to prevent any window to vehicle interference. The automatic
window function will not work with the battery disconnected.
Precaution for Power Generation Voltage Variable Control System
INFOID:0000000009160059
CAUTION:
For this model, the battery current sensor that is installed to the battery cable at the negative terminal
measures the charging/discharging current of the battery, and performs various controls. If the electri-
cal component or the ground wire is connected directly to the battery terminal, the current other than
that being measured with the battery current sensor is charging to or discharging from the battery.
This condition causes the malfunction of the control, and then the battery discharge may occur. Do
not connect the electrical component or the ground wire directly to the battery terminal.
CHG-12
< PREPARATION >
PREPARATION
PREPARATION
PREPARATION
Special Service Tools
INFOID:0000000009160060
Commercial Service Tools
INFOID:0000000009160061
Tool number
(Kent-Moore No.)
Tool name
Description
—
(—) Model GR8-1200 NI
Multitasking battery and electrical di-
agnostic station
Tests batteries, starting and charging sys-
tems and charges batteries.
For operating instructions, refer to diagnos-
tic station instruction instruction.
—
(—) Model EXP-800 NI
Battery and electrical diagnostic ana-
lyzer
Tests batteries and charging systems.
For operating instructions, refer to diagnos-
tic analyzer instruction instruction.
AWIIA1239ZZ
JSMIA0806ZZ
Tool name
Description
Power tool
Loosening bolts, nuts and screws
PIIB1407E
CHG
CHARGING SYSTEM PRELIMINARY INSPECTION
CHG-13
< PERIODIC MAINTENANCE >
C
D
E
F
G
H
I
J
K
L
B
A
O
P
N
PERIODIC MAINTENANCE
CHARGING SYSTEM PRELIMINARY INSPECTION
Inspection Procedure
INFOID:0000000009160062
1.
CHECK BATTERY TERMINALS CONNECTION
Check if battery terminals are clean and tight.
Is the inspection result normal?
YES
>> GO TO 2.
NO
>> Repair battery terminals connection.
2.
CHECK FUSE
Check for blown fuse and fusible link.
Is the inspection result normal?
YES
>> GO TO 3.
NO
>> Be sure to eliminate the cause of malfunction before installing new fuse.
3.
CHECK DRIVE BELT TENSION
Check drive belt tension. Refer to
.
Is the inspection result normal?
YES
>> INSPECTION END
NO
>> Repair as needed.
Unit
Power source (Power supply terminals)
Fuse No.
Alternator
Battery (“S” terminal)
38
Combination meter
Ignition switch ON (“L” terminal)
4
CHG-14
< SERVICE DATA AND SPECIFICATIONS (SDS)
SERVICE DATA AND SPECIFICATIONS (SDS)
SERVICE DATA AND SPECIFICATIONS (SDS)
SERVICE DATA AND SPECIFICATIONS (SDS)
Alternator
INFOID:0000000009160067
*: Adjustment range of power generation voltage variable control is 11.4 - 15.6 V.
Type
A002TX0091
MITSUBISHI make
Nominal rating
[V - A]
12 -150
Ground polarity
Negative
Minimum revolution under no-load (When 13.5 V is applied)
[rpm]
Less than 1,300
Hot output current (When 13.5 V is applied)
[A/rpm]
More than 57/1,500
More than 126/2,500
More than 152/5,000
Regulated output voltage
[V]
14.1 - 14.7
*
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст