Nissan Titan. Instruction — part 547
DIAGNOSIS AND REPAIR WORK FLOW
SRC-3
< BASIC INSPECTION >
C
D
E
F
G
I
J
K
L
M
A
B
SRC
N
O
P
BASIC INSPECTION
DIAGNOSIS AND REPAIR WORK FLOW
Work Flow
INFOID:0000000009882856
OVERALL SEQUENCE
DETAILED WORK FLOW
1.
CUSTOMER INFORMATION
Get detailed information from the customer about the symptom.
>> GO TO 2
2.
PRELIMINARY CHECK
Perform preliminary check. Refer to
SRC-13, "Trouble Diagnosis Introduction"
*1
SRC-13, "Trouble Diagnosis Intro-
duction"
*2
*3
SRC-60, "Trouble Diagnosis with
CONSULT"
*4
SRC-15, "Self-Diagnosis Function
(Without CONSULT)"
AWHIA0336GB
SRC-4
< BASIC INSPECTION >
DIAGNOSIS AND REPAIR WORK FLOW
>> GO TO 3
3.
USER MODE
Perform self-diagnosis using the AIR BAG warning lamp in User mode. Refer to
.
>> GO TO 4
4.
SELF-DIAGNOSIS
Perform SELF-DIAGNOSIS. Refer to
SRC-60, "Trouble Diagnosis with CONSULT"
62, "Trouble Diagnosis without CONSULT"
(without CONSULT).
>> GO TO 5
5.
TECHNICAL SERVICE BULLETINS
Check for technical service bulletins.
>> GO TO 6
6.
REPLACE PART
Replace the malfunctioning part.
>> GO TO 7
7.
FINAL CHECK
Check SRS using Diagnosis mode and User mode.
Does Diagnosis mode and User mode indicate SRS normal?
YES
>> Inspection end.
NO
>> GO TO 4
INTERMITTENTS INCIDENT
SRC-5
< BASIC INSPECTION >
C
D
E
F
G
I
J
K
L
M
A
B
SRC
N
O
P
INTERMITTENTS INCIDENT
Inspection Procedure
INFOID:0000000009882857
INTERMITTENT TROUBLE
An intermittent incident may have occurred in the past but is not being detected currently. This DTC will not be
detected on SELF DIAG [CURRENT], but may be viewed on SELF DIAG [PAST] using CONSULT.
Trouble Diagnosis with CONSULT
INFOID:0000000009882858
DIAGNOSTIC PROCEDURE 4
Check SRS Repair History
1.
CONSIDER POSSIBILITY THAT SELF-DIAGNOSTIC RESULT WAS NOT ERASED AFTER REPAIR
Check repair history of the SRS.
Have any previous repairs been made to the SRS?
Yes
>> Self-diagnostic result SELF-DIAG [PAST] (previously stored in the memory) might not be erased
after repair. Go to DIAGNOSTIC PROCEDURE 3. Refer to
SRC-15, "Self-Diagnosis Function
No
>> Go to DIAGNOSTIC PROCEDURE 2. Refer to
SRC-6
< SYSTEM DESCRIPTION >
SRS AIR BAG SYSTEM
SYSTEM DESCRIPTION
SRS AIR BAG SYSTEM
SRS Configuration
INFOID:0000000009882859
The air bag deploys if the air bag diagnosis sensor unit is activated while the ignition switch is in the ON or
START position.
The collision modes for which supplemental restraint systems are activated are different among the SRS sys-
tems. For example, the driver air bag module, front passenger air bag module and front seat belt pre-tension-
ers are activated in a frontal collision but not in a side collision.
SRS configurations for some collision modes are as follows:
WHIA0186E
SRS configuration
Frontal collision
Left side collision
Right side collision
Rollover
Driver air bag module
×
—
—
—
Front passenger air bag module
×
—
—
—
Front LH seat belt pre-tensioner
×
—
—
×
Front RH seat belt pre-tensioner
×
—
—
×
Front LH side air bag module
—
×
—
—
Front RH side air bag module
—
—
×
—
LH side curtain air bag module
—
×
—
×
RH side curtain air bag module
—
—
×
×
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст