Nissan Titan. Instruction — part 627
CONTROL CABLE
TM-191
< REMOVAL AND INSTALLATION >
C
E
F
G
H
I
J
K
L
M
A
B
TM
N
O
P
CONTROL CABLE
Exploded View
INFOID:0000000009885912
Removal and Installation
INFOID:0000000009885913
REMOVAL
1. Remove the A/T shift selector assembly. Refer to
TM-189, "A/T Shift Selector Removal and Installation"
.
2. Remove the heater and cooling unit assembly. Refer to
VTL-13, "Removal and Installation"
.
3. Remove the control cable retainer bolts.
4. Remove the control cable nut (1) and disconnect the control
cable from the instruction lever (2).
5. Remove the control cable from the vehicle.
INSTALLATION
Installation is in the reverse order of removal.
• Tighten the control cable nut (1) to specification.
1. Control cable
2. Instruction lever
3. Washer
4. Lock plate
5. Control cable bracket
6. A/T assembly
AWDIA0954GB
AWDIA1043ZZ
Control cable nut (1) : 14.6 N·m (1.5 kg-m, 11 ft-lb)
(2) : Instruction lever
AWDIA1043ZZ
TM-192
< REMOVAL AND INSTALLATION >
KEY INTERLOCK CABLE
KEY INTERLOCK CABLE
Component
INFOID:0000000009885914
CAUTION:
• Install key interlock cable in such a way that it will not be damaged by sharp bends, twists or interfer-
ence with adjacent parts.
• After installing key interlock cable to A/T shift selector, make sure that casing cap and bracket are
firmly secured in their positions. If casing cap can be removed with an external load of less than 39
N (4.0 kg, 8.8 lb), replace key interlock cable with new one.
Removal and Installation
INFOID:0000000009885915
REMOVAL (Floor shift models)
WCIA0467E
KEY INTERLOCK CABLE
TM-193
< REMOVAL AND INSTALLATION >
C
E
F
G
H
I
J
K
L
M
A
B
TM
N
O
P
1. Unlock slider from adjuster holder by squeezing lock tabs.
2. Remove casing cap from bracket of A/T shift selector assembly
and remove interlock rod from adjuster holder.
3. Remove holder from key cylinder and remove key interlock
cable.
REMOVAL (Column shift models)
1. Remove the instrument lower panel (LH). Refer to
IP-17, "Removal and Installation"
2. Remove the knee protector.
3. Disconnect shift lock cable.
4. Remove the key interlock cable.
INSTALLATION (Floor shift models)
SCIA1230E
LCIA0375E
LGIA0026E
TM-194
< REMOVAL AND INSTALLATION >
KEY INTERLOCK CABLE
1. Set key interlock cable to key cylinder and install holder.
2. Turn ignition key to "LOCK" position.
3. Set A/T shift selector to (P) position.
4. Insert interlock rod into adjuster holder.
5. Install casing cap to bracket.
6. Move slider in order to secure adjuster holder to interlock rod.
INSTALLATION (Column shift models)
1. Install key interlock cable to ignition key cylinder.
2. Connect the shift lock cable.
3. Install knee protector.
4. Install instrument lower panel (LH). Refer to
IP-17, "Removal and Installation"
SCIA2258E
SCIA1232E
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст