Nissan Titan. Instruction — part 630
CONTROL VALVE WITH TCM
TM-203
< REMOVAL AND INSTALLATION >
C
E
F
G
H
I
J
K
L
M
A
B
TM
N
O
P
10. Remove control valve with TCM from transmission case.
CAUTION:
When removing, be careful with the instruction valve notch and
instruction plate height. Remove it vertically.
11. Remove plug (1) with bracket (2) from control valve with TCM.
•
:Bolt
12. Remove the bracket (1) from plug (2).
13. Remove O-ring (1) from plug (2).
CAUTION:
Do not reuse O-ring.
SCIA5142E
JSDIA1311ZZ
JSDIA1312ZZ
JSDIA1313ZZ
TM-204
< REMOVAL AND INSTALLATION >
CONTROL VALVE WITH TCM
14. Remove O-ring from A/T assembly harness connector.
CAUTION:
Do not reuse O-ring.
15. Disconnect TCM connectors.
CAUTION:
Do not damage connectors.
16. Remove A/T assembly harness connector from control valve
with TCM using suitable tool.
17. Disconnect TCM connector (1) and transmission range switch
connector (2).
CAUTION:
Do not damage connectors.
Installation
CAUTION:
After completing installation, check A/T fluid leakage and fluid level. Refer to
.
SCIA5155E
SCIA5447E
SCIA5448E
JSDIA1317ZZ
CONTROL VALVE WITH TCM
TM-205
< REMOVAL AND INSTALLATION >
C
E
F
G
H
I
J
K
L
M
A
B
TM
N
O
P
1. Connect TCM connector (1) and transmission range switch con-
nector (2).
2. Install A/T assembly harness connector to control valve with
TCM.
3. Connect TCM connector.
4. Install new O-ring in A/T assembly harness connector.
CAUTION:
• Do not reuse O-ring.
• Apply ATF to O-ring.
5. Install new O-ring (1) in plug (2).
CAUTION:
• Do not reuse O-ring.
• Apply ATF to O-ring.
• O-ring should be free of contamination.
JSDIA1317ZZ
SCIA5450E
SCIA5447E
SCIA5155E
JSDIA1313ZZ
TM-206
< REMOVAL AND INSTALLATION >
CONTROL VALVE WITH TCM
6. Install plug (2) to bracket(1).
7. Install plug (1) [with bracket (2)] to control valve with TCM.
•
:Bolt
CAUTION:
Adjust bolt hole of bracket to bolt hole of control valve with
TCM.
8. Install control valve with TCM in transmission case.
CAUTION:
• Make sure that input speed sensor is securely installed
into input speed sensor hole (A).
• Hang down output speed sensor harness toward outside
so as not to disturb installation of control valve with TCM.
• Adjust A/T assembly harness connector of control valve
with TCM to terminal hole of transmission case.
• Assemble it so that instruction valve cutout is engaged with
instruction plate projection.
9. Install bolts (A), (B) and (C) in control valve with TCM.
JSDIA1312ZZ
JSDIA1311ZZ
(1)
: Brake band
JSDIA1318ZZ
SCIA5142E
: Front
Bolt symbol
Length mm (in)
Number of bolts
A
42 (1.65)
5
B
55 (2.17)
6
C
40 (1.57)
1
SCIA8074E
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст