Nissan Titan. Instruction — part 653
IN-CABIN MICROFILTER
VTL-5
< SYSTEM DESCRIPTION >
C
D
E
F
G
H
J
K
L
M
A
B
VTL
N
O
P
SYSTEM DESCRIPTION
IN-CABIN MICROFILTER
Description
INFOID:0000000009882377
FUNCTION
The air inside the passenger compartment is filtered by the in-cabin
microfilters when the heater or A/C controls are set on either the
recirculation or fresh mode. The two in-cabin microfilters are located
in the heater and cooling unit assembly.
REPLACEMENT TIMING
Replacement of the two in-cabin microfilters is recommended on a regular interval depending on the driving
conditions. Refer to For
MA-9, "FOR NORTH AMERICA : Introduction of Periodic Maintenance"
(United States
and Canada) or
MA-12, "FOR MEXICO : Introduction of Periodic Maintenance"
(Mexico). It may also be nec-
essary to replace the two in-cabin microfilters as part of a component replacement if the in-cabin microfilters
are damaged.
LJIA0012E
VTL-6
< PERIODIC MAINTENANCE >
IN-CABIN MICROFILTER
PERIODIC MAINTENANCE
IN-CABIN MICROFILTER
Removal and Installation
INFOID:0000000009882378
REPLACEMENT PROCEDURE
1. Remove the two lower glove box hinge pins to remove the glove
box from the instrument panel and let it hang from the cord.
2. Remove the screw and remove the in-cabin microfilter cover.
3. Remove the in-cabin microfilters from the heater and cooling
unit assembly housing.
4. Insert the first new in-cabin microfilter into the heater and cool-
ing unit assembly housing and slide it over to the right. Insert the
second new in-cabin microfilter into the heater and cooling unit
assembly housing.
NOTE:
The in-cabin microfilters are marked with air flow arrows. The
end of the microfilter with the arrow should face the rear of the
vehicle. The arrows should point downward.
5. Install the in-cabin microfilter cover.
WLIA0027E
LJIA0134E
LJIA0148E
LJIA0134E
IN-CABIN MICROFILTER
VTL-7
< PERIODIC MAINTENANCE >
C
D
E
F
G
H
J
K
L
M
A
B
VTL
N
O
P
6. Install the lower glove box in the instrument panel and secure it
with the two hinge pins.
WLIA0027E
VTL-8
< REMOVAL AND INSTALLATION >
CONTROL UNIT
REMOVAL AND INSTALLATION
CONTROL UNIT
Removal and Installation
INFOID:0000000009882379
REMOVAL
1. Remove cluster lid C. Refer to
IP-15, "Removal and Installation"
2. Remove the four screws (A) that retain the front air control unit
(1) to cluster lid D (2).
3. Remove the front air control unit (1).
4. Remove the control knobs from the front air control unit.
INSTALLATION
Installation is in the reverse order of removal.
ALIIA0078ZZ
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст