Nissan Pathfinder (2009 year). Instruction — part 467
REFRIGERATION SYSTEM
HAC-131
< FUNCTION DIAGNOSIS >
[MANUAL AIR CONDITIONER]
C
D
E
F
G
H
J
K
L
M
A
B
HAC
N
O
P
The refrigerant system is protected against excessively high- or low-pressures by the refrigerant pressure sen-
sor, located on the condenser. If the system pressure rises above or falls below the specifications, the refriger-
ant pressure sensor detects the pressure inside the refrigerant line and sends a voltage signal to the ECM.
The ECM de-energizes the A/C relay to disengage the magnetic compressor clutch when pressure on the high
pressure side detected by refrigerant pressure sensor is over about 2,746 kPa (28 kg/cm
2
, 398 psi), or below
about 120 kPa (1.22 kg/cm
2
, 17.4 psi).
PRESSURE RELIEF VALVE
The refrigerant system is also protected by a pressure relief valve, located in the rear head of the compressor.
When the pressure of refrigerant in the system increases to an abnormal level [more than 2,990 kPa (30.5 kg/
cm
2
, 433.6 psi)], the release port on the pressure relief valve automatically opens and releases refrigerant into
the atmosphere.
2009 Pathfinder
HAC-132
< FUNCTION DIAGNOSIS >
[MANUAL AIR CONDITIONER]
MANUAL AIR CONDITIONER SYSTEM
MANUAL AIR CONDITIONER SYSTEM
Control System Diagram
INFOID:0000000003935954
CONTROL SYSTEM
The control system consists of input sensors, switches, the front air control (microcomputer) and outputs.
The relationship of these components is shown in the figure below:
Control System Description
INFOID:0000000003935955
CONTROL OPERATION
Front air control
AWIIA0592GB
WJIA1510E
2009 Pathfinder
MANUAL AIR CONDITIONER SYSTEM
HAC-133
< FUNCTION DIAGNOSIS >
[MANUAL AIR CONDITIONER]
C
D
E
F
G
H
J
K
L
M
A
B
HAC
N
O
P
TEMPERATURE CONTROL DIAL (TEMPERATURE CONTROL)
Increases or decreases the set temperature.
RECIRCULATION (
) SWITCH
• When REC switch is ON, REC switch indicator turns ON, and air inlet is set to REC.
• When REC switch is turned OFF, or when compressor is turned from ON to OFF, REC switch is automati-
cally turned OFF. REC mode can be re-entered by pressing REC switch again.
• REC switch is not operated when DEF switch is turned ON, or at the D/F or FOOT position.
DEFROSTER (
) SWITCH
Positions the air outlet doors to the defrost position. Also positions the intake doors to the outside air position.
REAR WINDOW DEFOGGER SWITCH
When switch is ON, rear window is defogged.
OFF SWITCH (BLOWER SPEED SET TO 0)
The compressor and blower are OFF.
A/C SWITCH
The compressor is ON or OFF.
(Pressing the A/C switch will turn off the A/C switch and compressor.)
MODE DIAL
Controls the air discharge outlets.
FRONT BLOWER CONTROL DIAL
Instructionly controls the four blower speeds.
MAGNET CLUTCH CONTROL
When the A/C switch is pressed, or the mode dial is turned to the DEF or D/F position, the front air control out-
puts a compressor ON signal to BCM.
The BCM then sends a compressor ON signal to ECM, via CAN communication line.
ECM judges whether compressor can be turned ON, based on each sensor status (refrigerant pressure sen-
sor signal, throttle angle sensor, etc.). If it judges compressor can be turned ON, it sends compressor ON sig-
nal to IPDM E/R, via CAN communication line.
Upon receipt of compressor ON signal from ECM, IPDM E/R turns air conditioner relay ON to operate com-
pressor.
1.
Temperature control dial
2.
Blower control dial
3.
A/C switch
4.
Rear window defogger switch
5.
Recirculation switch
6.
Mode dial
WJIA1293E
2009 Pathfinder
HAC-134
< FUNCTION DIAGNOSIS >
[MANUAL AIR CONDITIONER]
MANUAL AIR CONDITIONER SYSTEM
Discharge Air Flow
INFOID:0000000003935956
Switches And Their Control Function
INFOID:0000000003935957
SWITCHES AND THEIR CONTROL FUNCTION
Mode door position
Air outlet/distribution
Vent
Foot
Defroster
95%
5%
—
60%
40%
—
20%
55%
25%
15%
50%
35%
7%
15%
78%
Airflow always present at driver and passenger side demisters
WJIA1296E
AWIIA0271GB
2009 Pathfinder
MANUAL AIR CONDITIONER SYSTEM
HAC-135
< FUNCTION DIAGNOSIS >
[MANUAL AIR CONDITIONER]
C
D
E
F
G
H
J
K
L
M
A
B
HAC
N
O
P
WJIA1497E
2009 Pathfinder
HAC-136
< FUNCTION DIAGNOSIS >
[MANUAL AIR CONDITIONER]
DIAGNOSIS SYSTEM (BCM)
DIAGNOSIS SYSTEM (BCM)
CONSULT-III Function (BCM - COMMON ITEM)
INFOID:0000000004375775
APPLICATION ITEM
CONSULT-III performs the following functions via CAN communication with BCM.
SYSTEM APPLICATION
BCM can perform the following functions for each system.
NOTE:
It can perform the diagnosis modes except the following for all sub system selection items.
1: With remote keyless entry system
2: With Intelligent Key
CONSULT-III Function (BCM - AUTO AIR CONDITIONER)
INFOID:0000000004375776
DATA MONITOR
Diagnosis mode
Function Description
WORK SUPPORT
Changes the setting for each system function.
SELF-DIAG RESULTS
Displays the diagnosis results judged by BCM. Refer to
CAN DIAG SUPPORT MNTR
Monitors the reception status of CAN communication viewed from BCM.
DATA MONITOR
The BCM input/output signals are displayed.
ACTIVE TEST
The signals used to activate each device are forcibly supplied from BCM.
ECU IDENTIFICATION
The BCM part number is displayed.
CONFIGURATION
• Enables to read and save the vehicle specification.
• Enables to write the vehicle specification when replacing BCM.
System
Sub system selection item
Diagnosis mode
WORK SUPPORT
DATA MONITOR
ACTIVE TEST
BCM
BCM
×
Door lock
DOOR LOCK
×
×
×
Rear window defogger
REAR DEFOGGER
×
Warning chime
BUZZER
×
×
Interior room lamp timer
INT LAMP
×
×
×
Remote keyless entry system
1
MULTI REMOTE ENT
×
×
×
Exterior lamp
HEAD LAMP
×
×
×
Wiper and washer
WIPER
×
×
×
Turn signal and hazard warning lamps
FLASHER
×
×
Air conditioner
AIR CONDITONER
×
Intelligent Key system
2
INTELLIGENT KEY
×
Combination switch
COMB SW
×
Immobilizer
IMMU
×
×
Interior room lamp battery saver
BATTERY SAVER
×
×
×
Back door open
TRUNK
×
×
RAP (retained accessory power)
RETAINED PWR
×
×
×
Signal buffer system
SIGNAL BUFFER
×
×
TPMS (tire pressure monitoring sys-
tem)
AIR PRESSURE MONITOR
×
×
×
Vehicle security system
PANIC ALARM
×
2009 Pathfinder
DIAGNOSIS SYSTEM (BCM)
HAC-137
< FUNCTION DIAGNOSIS >
[MANUAL AIR CONDITIONER]
C
D
E
F
G
H
J
K
L
M
A
B
HAC
N
O
P
Monitor Item
[Unit]
Contents
IGN ON SW [ON/OFF]
Display [ignition switch position (On)/(Off), ACC position (Off)] status as judged from ignition
switch signal
FAN ON SIG [ON/OFF]
Display [FAN (On)/FAN (Off)] status as judged form blower fan motor switch signal
AIR COND SW [ON/OFF]
Display [COMP (On)/COMP (Off)] status as judged form air conditioner switch signal
2009 Pathfinder
HAC-138
< COMPONENT DIAGNOSIS >
[MANUAL AIR CONDITIONER]
MODE DOOR MOTOR
COMPONENT DIAGNOSIS
MODE DOOR MOTOR
System Description
INFOID:0000000003935960
SYSTEM DESCRIPTION
Component Parts
Mode door control system components are:
• Front air control
• Mode door motor
• PBR (built into mode door motor)
• Intake sensor
System Operation
The mode door position (vent, B/L, foot, D/F, and defrost) is set by the front air control by means of the mode
door motor. When a mode door position is selected on the front air control, voltage is applied to one circuit of
the mode door motor while ground is applied to the other circuit, causing the mode door motor to rotate. The
direction of rotation is determined by which circuit has voltage applied to it, and which one has ground applied
to it. The front air control monitors the mode door position by measuring the voltage signal on the PBR circuit.
COMPONENT DESCRIPTION
Mode Door Motor
The mode door motor is attached to the heater and cooling unit
assembly. It rotates so that air is discharged from the outlet as indi-
cated by the front air control. Motor rotation is conveyed to a link
which activates the mode door.
Mode Door Motor (Front) Component Function Check
INFOID:0000000003935961
SYMPTOM:
• Air outlet does not change.
• Mode door motor does not operate normally.
WJIA1314E
WJIA1484E
2009 Pathfinder
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст