Nissan Qashqai (2007-2010). Manual — part 1322
MIR-34
< PRECAUTION >
PRECAUTIONS
PRECAUTION
PRECAUTIONS
Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TEN-
SIONER"
INFOID:0000000000951544
The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-TENSIONER”, used along
with a front seat belt, helps to reduce the risk or severity of injury to the driver and front passenger for certain
types of collision. This system includes seat belt switch inputs and dual stage front air bag modules. The SRS
system uses the seat belt switches to determine the front air bag deployment, and may only deploy one front
air bag, depending on the severity of a collision and whether the front occupants are belted or unbelted.
Information necessary to service the system safely is included in the SRS and SB section of this Service Man-
ual.
WARNING:
• To avoid rendering the SRS inoperative, which could increase the risk of personal injury or death in
the event of a collision which would result in air bag inflation, all maintenance must be performed by
an authorized NISSAN/INFINITI dealer.
• Improper maintenance, including incorrect removal and installation of the SRS, can lead to personal
injury caused by unintentional activation of the system. For removal of Spiral Cable and Air Bag
Module, see the SRS section.
• Do not use electrical test equipment on any circuit related to the SRS unless instructed to in this
Service Manual. SRS wiring harnesses can be identified by yellow and/or orange harnesses or har-
ness connectors.
PREPARATION
MIR-35
< PREPARATION >
C
D
E
F
G
H
I
J
K
M
A
B
MIR
N
O
P
PREPARATION
PREPARATION
Commercial Service Tools
INFOID:0000000000951545
Tool name
Description
Engine ear
Locating the noise
Suction lifter
Holding the door glass
SIIA0995E
PIIB1805J
MIR-36
< ON-VEHICLE MAINTENANCE >
PRE-INSPECTION FOR DIAGNOSTIC
ON-VEHICLE MAINTENANCE
PRE-INSPECTION FOR DIAGNOSTIC
Basic Inspection
INFOID:0000000000977987
BASIC INSPECTION
1.
INSPECTION START
1.
Check the service history.
2.
Check the following parts.
• Fuse/circuit breaker blown.
• Poor connection, open or short circuit of harness connector.
• Battery voltage.
Is the inspection result normal?
YES
>> Inspection end.
NO
>> Repair or replace the malfunctioning parts.
INSIDE MIRROR
MIR-37
< ON-VEHICLE REPAIR >
C
D
E
F
G
H
I
J
K
M
A
B
MIR
N
O
P
ON-VEHICLE REPAIR
INSIDE MIRROR
Exploded View
INFOID:0000000001093107
Removal and Installation
INFOID:0000000001093108
REMOVAL
1.
Remove the inside mirror finisher (upper and lower).
2.
Slide the mirror upward to remove.
3.
Disconnect the connector.
INSTALLATION
Install in the reverse order of removal.
1.
Inside mirror cover (upper)
2.
Inside mirror
3.
Inside mirror cover (lower)
4.
Mirror base
5.
Connector
for symbols in the figure.
JMLIA0037ZZ
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст