Nissan Qashqai (2007-2010). Manual — part 826
B1202, B1203, B1204, B1205, B1206, B1207 DIAGNOSIS SENSOR UNIT
SRC-191
< COMPONENT DIAGNOSIS >
C
D
E
F
G
I
J
K
L
M
A
B
SRC
N
O
P
B1202, B1203, B1204, B1205, B1206, B1207 DIAGNOSIS SENSOR UNIT
Description
INFOID:0000000001069909
DTC B1202, B1203, B1204, B1205, B1206, B1207 DIAGNOSIS SENSOR UNIT
Detects the whole SRS electrical system and displays the malfunction either by illuminating or blinking the air
bag warning lamp in the combination meter Malfunctioning part can be detected by on board self-diagnosis
system and electro-diagnosis tester “CONSULT-III”.
OPERATION
It detects a shock that exceeds specified level and watches such systems as the driver and passenger air bag,
side air bag, curtain air bag, pre-tensioner seat belts operate properly.
STRUCTURE
It contains the “G” sensors of both for frontal collision and for side collision and spare battery function in case
of main battery damage in collision.
INSTALLATION
SRS diagnosis sensor unit is installed under the center console with fixed bolts.
DTC Logic
INFOID:0000000001069910
DTC DETECTION LOGIC
With CONSULT-III
DTC No. Index (“SELF-DIAG [CURRENT]”), (“SELF-DIAG [PAST]” or “TROUBLE DIAG RECORD”)
Without CONSULT-III
Warning Lamp Flash Code Chart
DTC CONFIRMATION PROCEDURE (With CONSULT-III)
1.
IGNITION SWITCH
Turn ignition switch ON.
>> GO TO 2.
2.
CONSULT-III
Check the “SELF-DIAG” RESULT with CONSULT-III.
DTC No.
Trouble diagnosis name
DTC detecting condition
Possible cause
B1202
B1203
B1204
B1205
B1206
B1207
DIAGNOSIS SENSOR
UNIT
Diagnosis sensor unit is out of order.
1.
Replace diagnosis sensor unit
(ACU).
JMHIA0034GB
SRC-192
< COMPONENT DIAGNOSIS >
B1202, B1203, B1204, B1205, B1206, B1207 DIAGNOSIS SENSOR UNIT
>> GO TO 3.
3.
DTC CODE
If DTC is detected. Refer to
>> END
DTC CONFIRMATION PROCEDURE (Without CONSULT-III)
NOTE:
• SRS will not enter diagnosis mode if no malfunction is detected in user mode.
1.
IGNITION SWITCH
Turn ignition switch ON.
>> GO TO 2.
2.
USER MODE-DIAG MODE
After air bag warning lamp illuminates for 7 seconds, turn ignition switch OFF within 1 second.
>> GO TO 3.
3.
USER MODE-DIAG MODE
Wait more than 3 seconds.
>> GO TO 4.
4.
USER MODE-DIAG MODE
Repeat step 1 to 3 twice. (Perform three times in all.)
>> GO TO 5.
5.
DIAG MODE
Turn ignition switch ON. (SRS is now in diagnosis mode.)
>> GO TO 6.
6.
DIAG MODE (AIR BAG WARNING LAMP)
Malfunctioning portion is indicated according to blinking times of air bag warning lamp. Refer to
>> END
Diagnosis Procedure (Component diagnosis)
INFOID:0000000001069911
B1202, B1203, B1204, B1205, B1206, B1207 DIAGNOSIS SENSOR UNIT
SRC-193
< COMPONENT DIAGNOSIS >
C
D
E
F
G
I
J
K
L
M
A
B
SRC
N
O
P
With CONSULT-III
CAUTION:
• Before servicing, turn ignition switch OFF, disconnect both battery terminals and wait at least 3 min-
utes. (To discharge backup capacitor.)
• Do not use unspecified tester or other measuring device.
DIAGNOSTIC PROCEDURE
1.
CHECK HARNESS CONNECTOR
Are connections of harness connectors and terminals correct?
YES
>> GO TO 2.
NO
>> Repair or replace harness connectors.
2.
CHECK WIRING HARNESS
Is the outside of wiring harness normal, without any damage?
YES
>> GO TO 3.
NO
>> Replace wiring harness.
3.
CHECK DIAGNOSIS SENSOR UNIT
Is “DIAGNOSIS SENSOR UNIT” displayed on CONSULT-III?
YES
>> Replace diagnosis sensor unit (ACU).
>> INSPECTION END.
SRC-194
< COMPONENT DIAGNOSIS >
B1209 FRONTAL COLLISION DETECTION
B1209 FRONTAL COLLISION DETECTION
Description
INFOID:0000000001069912
DTC B1209 FRONTAL COLLISION DETECTION
If the components that are not activated in frontal collision are reused, they should be checked for damage by
CONSULT-lll or air bag warning lamp. Repair or replace malfunctioning components.
OPERATION
The air bag and seat belt pre-tensioners for driver and front seat passenger are operated by the decision of
the diagnosis sensor unit out signaltransmitted because of the frontal collision.
STRUCTURE
It consists of crash zone sensor, diagnosis sensor unit (ACU), air bags and seat belt pre-tensioners for drivers
and front passenger.
INSTALLATION
Refer to
SR-14, "Removal and Installation"
SR-16, "Removal and Installation"
,
SR-8, "Removal and Installation"
,
SR-18, "Removal and Installation"
DTC Logic
INFOID:0000000001069913
DTC DETECTION LOGIC
With CONSULT-III
DTC No. Index (“SELF-DIAG [CURRENT]”), (“SELF-DIAG [PAST]” or “TROUBLE DIAG RECORD”)
DTC CONFIRMATION PROCEDURE (With CONSULT-III)
1.
IGNITION SWITCH
Turn ignition switch ON.
>> GO TO 2.
2.
CONSULT-III
Check the “SELF-DIAG” RESULT with CONSULT-III.
>> GO TO 3.
3.
DTC CODE
If DTC is detected. Refer to
>> END
Diagnosis Procedure (Component diagnosis)
INFOID:0000000001069914
DTC No.
Trouble diagnosis name
DTC detecting condition
Possible cause
B1209
FRONTAL COLLISION
DETECTION
Seat belt pretensioner, front air bag is
deployed.
• Go to
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст