Nissan Pathfinder (2010 year). Instruction — part 529
PG-64
< COMPONENT DIAGNOSIS >
HARNESS
B3
D405
W/8
: To D501
D3 D550
W/8
: To D451
A3
D406
—
: Body ground
D3 D551
W/4
: Rear view camera
C1 D408
W/4
: To D601
D4 D552
GR/2
: Back door request switch
C1 D409
W/1
: To D650
E4
D554
—
: Body ground
F3
D450
W/8
: To B107
Rear window sub-harness
E3
D451
W/8
: To D550
C1 D601
W/4
: To D408
E3
D455
—
: Body ground
D2 D602
W/4
: Rear wiper motor
Back door harness
E1
D603
—
: Body ground
C3 D501
W/8
: To D405
F2
D604
B/1
: Rear window defogger
C4 D502
W/4
: Back door latch
D1 D605
W/2
: High-mounted stop lamp
D2 D503
B/1
: Glass hatch ajar switch
Back door LH harness
D3 D504
—
: Body ground
B1
D650
W/1
: To D409
C4 D505
W/4
: To D404
B2
D651
B/1
: Rear window defogger
D4 D506
BR/2
: License plate lamp LH
2010 Pathfinder
PG
ELECTRICAL UNITS LOCATION
PG-65
< COMPONENT DIAGNOSIS >
C
D
E
F
G
H
I
J
K
L
B
A
O
P
N
ELECTRICAL UNITS LOCATION
Electrical Units Location
INFOID:0000000005260661
ENGINE COMPARTMENT
ABMIA0309GB
2010 Pathfinder
PG-66
< COMPONENT DIAGNOSIS >
ELECTRICAL UNITS LOCATION
PASSENGER COMPARTMENT
ABMIA1383GB
2010 Pathfinder
PG
ELECTRICAL UNITS LOCATION
PG-67
< COMPONENT DIAGNOSIS >
C
D
E
F
G
H
I
J
K
L
B
A
O
P
N
ABMIA1384GB
2010 Pathfinder
PG-68
< COMPONENT DIAGNOSIS >
HARNESS CONNECTOR
HARNESS CONNECTOR
Description
INFOID:0000000005260662
HARNESS CONNECTOR (TAB-LOCKING TYPE)
• The tab-locking type connectors help prevent accidental looseness or disconnection.
• The tab-locking type connectors are disconnected by pushing or lifting the locking tab(s). Refer to the illus-
tration below.
Refer to the next page for description of the slide-locking type connector.
CAUTION:
Do not pull the harness or wires when disconnecting the connector.
[Example]
HARNESS CONNECTOR (SLIDE-LOCKING TYPE)
• A new style slide-locking type connector is used on certain systems and components, especially those
related to OBD.
• The slide-locking type connectors help prevent incomplete locking and accidental looseness or disconnec-
tion.
• The slide-locking type connectors are disconnected by pushing or pulling the slider. Refer to the illustration
below.
SEL769DA
2010 Pathfinder
PG
HARNESS CONNECTOR
PG-69
< COMPONENT DIAGNOSIS >
C
D
E
F
G
H
I
J
K
L
B
A
O
P
N
CAUTION:
• Do not pull the harness or wires when disconnecting the connector.
• Be careful not to damage the connector support bracket when disconnecting the connector.
[Example]
HARNESS CONNECTOR (LEVER LOCKING TYPE)
• Lever locking type harness connectors are used on certain control units and control modules such as ECM,
ABS actuator and electric unit (control unit), etc.
• Lever locking type harness connectors are also used on super multiple junction (SMJ) connectors.
• Always confirm the lever is fully locked in place by moving the lever as far as it will go to ensure full connec-
tion.
CAUTION:
AEL299C
2010 Pathfinder
PG-70
< COMPONENT DIAGNOSIS >
HARNESS CONNECTOR
Always confirm the lever is fully released (loosened) before attempting to disconnect or connect these
connectors to avoid damage to the connector housing or terminals.
HARNESS CONNECTOR (DIRECT-CONNECT SRS COMPONENT TYPE)
• SRS direct-connect type harness connectors are used on certain SRS components such as air bag modules
and seat belt pre-tensioners.
• Always pull up to release black locking tab prior to removing connector from SRS component.
• Always push down to lock black locking tab after installing connector to SRS component. When locked, the
black locking tab is level with the connector housing.
CAUTION:
• Do not pull the harness or wires when removing connectors
from SRS components.
LKIA0670E
1.
Control unit with single lever
A. Fasten
B. Loosen
C. Lever
2.
Control unit with dual levers
A. Levers
B. Fasten
C. Loosen
3.
SMJ connector
A. Lever
B. Fasten
C. Loosen
WHIA0103E
2010 Pathfinder
PG
STANDARDIZED RELAY
PG-71
< COMPONENT DIAGNOSIS >
C
D
E
F
G
H
I
J
K
L
B
A
O
P
N
STANDARDIZED RELAY
Description
INFOID:0000000005260663
NORMAL OPEN, NORMAL CLOSED AND MIXED TYPE RELAYS
Relays can mainly be divided into three types: normal open, normal closed and mixed type relays.
TYPE OF STANDARDIZED RELAYS
SEL881H
SEL882H
1M
1 Make
2M
2 Make
1T
1 Transfer
1M·1B
1 Make 1 Break
2010 Pathfinder
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст