Nissan Tiida C11. Instruction — part 1465
WIPER AND WASHER SYSTEM SYMPTOMS
WW-55
< SYMPTOM DIAGNOSIS >
C
D
E
F
G
H
I
J
K
M
A
B
WW
N
O
P
Front wiper does not
stop.
HI only
• Combination switch
• BCM
Combination switch
Refer to
Front wiper request signal
• BCM
• IPDM E/R
IPDM E/R DATA MONITOR
"FR WIP REQ"
IPDM E/R
—
LO only
• Combination switch
• BCM
Combination switch
Refer to
Front wiper request signal
• BCM
• IPDM E/R
IPDM E/R DATA MONITOR
"FR WIP REQ"
IPDM E/R
—
INT only
• Combination switch
• BCM
Combination switch
Refer to
XX-XX, "*****"
.
Front wiper request signal
• BCM
• IPDM E/R
IPDM E/R DATA MONITOR
"FR WIP REQ"
Front wiper does not
operate normally.
Intermittent adjustment
cannot be performed.
• Combination switch
• Harness between combination switch and BCM
• BCM
Combination switch
Refer to
BCM
—
Intermittent control
linked with vehicle
speed cannot be per-
formed.
Check the vehicle speed detection wiper setting.
Refer to
WW-14, "WIPER : CONSULT-III Function (BCM - WIPER)"
Wiper is not linked to
the washer operation.
• Combination switch
• Harness between combination switch and BCM
• BCM
Combination switch
Refer to
BCM
—
Does not return to stop
position (Repeatedly
operates for 10 sec-
onds and then stops
for 20 seconds. After
that, it stops the opera-
tion).
• IPDM E/R
• Harness between IPDM E/R and front wiper
motor
• Front wiper motor
Front wiper auto stop signal
circuit
Refer to
.
Front wiper auto op-
eration does not op-
erate. (If equipped)
Any
• Light and rain sensor
• Harness between combination switch and BCM
• BCM
Light and rain sensor
Refer to
.
• IPDM E/R
• Harness between IPDM E/R and front wiper
motor
• Front wiper motor
IPDM E/R
Refer to xxx.
BCM
—
Symptom
Probable malfunction location
Inspection item
WW-56
< SYMPTOM DIAGNOSIS >
WIPER AND WASHER SYSTEM SYMPTOMS
Rear wiper does not
operate.
ON only
• Combination switch
• Harness between combination switch and BCM
• BCM
Combination switch
Refer to
INT only
• Combination switch
• Harness between combination switch and BCM
• BCM
Combination switch
Refer to
ON and INT
• Combination switch
• Harness between combination switch and BCM
• BCM
Combination switch
Refer to
• BCM
• Harness between rear wiper motor and BCM
• Harness between rear wiper motor and ground
• Rear wiper motor
Combination switch
Refer to
.
Rear wiper does not
stop.
ON only
• Combination switch
• BCM
Rear wiper motor circuit
Refer to
.
INT only
• Combination switch
• BCM
Combination switch
Refer to
Rear wiper does not
operate normally.
Wiper is not linked to
the washer operation.
• Combination switch
• Harness between rear wiper motor and BCM
• BCM
Combination switch
Refer to
BCM
—
Rear wiper does not
return to the Stop posi-
tion (Stops after a five-
second operation).
• BCM
• Harness between rear wiper motor and BCM
• Rear wiper motor
Rear wiper auto stop signal
circuit
Refer to
.
Rear wiper stops after
operating for five sec-
onds when ignition
switch is turned ON.
Headlamp washer
does not operate.
Headlamp washer
does not operate with
the front washer when
headlamps are turned
ON.
• Combination switch
• Harness between combination switch and BCM
• BCM
• Headlamp washer pump
Combination switch
Refer to
• Fusible link
• Harness between fusible link and headlamp
washer relay
• Headlamp washer relay
• Harness between headlamp washer relay and
IPDM E/R
• IPDM E/R
• Harness between headlamp washer relay and
headlamp washer pump
• Harness between headlamp washer pump and
ground
• Headlamp washer pump
Headlamp washer circuit
Refer to
.
BCM
—
Symptom
Probable malfunction location
Inspection item
NORMAL OPERATING CONDITION
WW-57
< SYMPTOM DIAGNOSIS >
C
D
E
F
G
H
I
J
K
M
A
B
WW
N
O
P
NORMAL OPERATING CONDITION
Description
INFOID:0000000001366641
FRONT WIPER MOTOR PROTECTION FUNCTION
• IPDM E/R may stop the front wiper to protect the front wiper motor if any obstruction (operation resistance)
such as a large amount of snow is detected during the front wiper operation.
• At that time turn OFF the front wiper and remove the foreign object. Then wait for approximately 20 seconds
or more and reactivate the front wiper. The wiper will operate normally.
REAR WIPER MOTOR PROTECTION FUNCTION
• BCM may stop rear wiper to protect the rear wiper motor when the rear wiper is stopped for 5 seconds or
more due to a snowfall.
• Rear wiper operates normally one minute after the obstacles are removed with rear wiper OFF.
WW-58
< SYMPTOM DIAGNOSIS >
FRONT WIPER DOES NOT OPERATE
FRONT WIPER DOES NOT OPERATE
Description
INFOID:0000000001366642
The front wiper does not operate under any operation conditions.
Diagnosis Procedure
INFOID:0000000001366643
1.
CHECK WIPER RELAY OPERATION
IPDM E/R AUTO ACTIVE TEST
1.
Start IPDM E/R auto active test. Refer to
PCS-10, "Diagnosis Description"
2.
Check that the front wiper operates at the LO/HI operation.
CONSULT-III ACTIVE TEST
1.
Select "FRONT WIPER" of IPDM E/R active test item.
2.
While operating the test item, check front wiper operation.
Is front wiper operation normal?
YES
>> GO TO 5
NO
>> GO TO 2
2.
CHECK FRONT WIPER MOTOR FUSE
1.
Turn the ignition switch OFF.
2.
Check that the following fuse is not blown.
Is the fuse blown?
YES
>> Replace the fuse after repairing the applicable circuit.
NO
>> GO TO 3
3.
CHECK FRONT WIPER MOTOR GROUND OPEN CIRCUIT
1.
Disconnect front wiper motor.
2.
Check continuity between front wiper motor harness connector
and ground.
Does continuity exist?
YES
>> GO TO 4
NO
>> Repair or replace harness.
4.
CHECK FRONT WIPER MOTOR OUTPUT VOLTAGE
CONSULT-III ACTIVE TEST
LO
: Front wiper LO operation
HI
: Front wiper HI operation
OFF
: Stop the front wiper.
Unit
Location
Fuse No.
Capacity
Front wiper motor
IPDM E/R
39
30 A
Front wiper motor
Ground
Continuity
Connector
Terminal
E1
2
Yes
WKIA5488E
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст