Nissan Tiida C11. Instruction — part 698
EM-144
< ON-VEHICLE MAINTENANCE >
[MR18DE]
AIR CLEANER FILTER
AIR CLEANER FILTER
Removal and Installation
INFOID:0000000001528960
REMOVAL
1.
Push the tabs (A) of both ends of the air cleaner cover (1) into
the inside (B).
2.
Pull up the air cleaner cover (1) and remove it (C).
3.
Remove air cleaner filter (1) and holder (2) assembly from the
air cleaner case.
4.
Remove the air cleaner filter (1) from the holder (2).
INSPECTION AFTER REMOVAL
It is necessary to clean air cleaner filter or replace it at the recommended intervals, more often under dusty
conditions. Refer to
.
• Blow air into the back side of air cleaner filter until no objects spray
out.
INSTALLATION
Installation is in the reverse order of removal.
• Install the air cleaner cover (1) in the direction shown.
PBIC3557J
PBIC3558J
SMA384C
2
: Air cleaner filter
3
: Holder
PBIC3559J
SPARK PLUG
EM-145
< ON-VEHICLE MAINTENANCE >
[MR18DE]
C
D
E
F
G
H
I
J
K
L
M
A
EM
N
P
O
SPARK PLUG
Component
INFOID:0000000001346458
Removal and Installation
INFOID:0000000001346459
REMOVAL
1.
Remove intake manifold. Refer to
EM-156, "Removal and Installation"
2.
Remove ignition coil.
CAUTION:
• Handle it carefully and avoid impacts.
• Never disassemble.
1.
PCV hose
2.
Rocker cover
3.
Spark plug
4.
Ignition coil
5.
PCV hose
6.
PCV valve
7.
O-ring
8.
Gasket
A.
To air duct
B.
C.
To intake manifold
PBIC3536J
EM-146
< ON-VEHICLE MAINTENANCE >
[MR18DE]
SPARK PLUG
3.
Remove spark plug using suitable tool.
CAUTION:
Never drop or shock it.
INSPECTION AFTER REMOVAL
CAUTION:
• Never drop or shock spark plug.
• Checking and adjusting spark plug gap is not required
between change intervals.
• If spark plug tip is covered with carbon, a spark plug cleaner may be used.
• Never use wire brush for cleaning spark plug.
INSTALLATION
1.
Install spark plug using suitable tool.
CAUTION:
Never drop or shock it.
2.
Install ignition coil.
PBIC3871E
SMA806CA
Cleaner air pressure
: Less than 588 kPa (5.88 bar, 6 kg/cm
2
, 85 psi)
Cleaning time
: Less than 20 seconds
SMA773C
Plug type
: Platinum tipped
Make
: NGK
Part number
: PLZKAR6A-11
Gap (nominal)
: 1.1 mm (0.043 in)
PBIC3871E
SPARK PLUG
EM-147
< ON-VEHICLE MAINTENANCE >
[MR18DE]
C
D
E
F
G
H
I
J
K
L
M
A
EM
N
P
O
CAUTION:
• Handle it carefully and avoid impacts.
• Never disassemble.
3.
Install intake manifold. Refer to
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст