Nissan Tiida C11. Instruction — part 152
DLK-18
< BASIC INSPECTION >
[WITH I-KEY, WITHOUT SUPER LOCK]
DIAGNOSIS AND REPAIR WORKFLOW
9.
REPAIR OR REPLACE THE MALFUNCTIONING PART
1.
Repair or replace the malfunctioning part.
2.
Reconnect parts or connectors disconnected during Diagnostic Procedure again after repair and replace-
ment.
3.
Check DTC. If DTC is displayed, erase it.
>> GO TO 10.
10.
FINAL CHECK
When DTC was detected in step 9, perform DTC Confirmation Procedure or Component Function Check
again, and then check that the malfunctions have been fully repaired.
When symptom was described by the customer, refer to the confirmed symptom in step 3 or 4, and check that
the symptom is not detected.
Does the symptom reappear?
YES (DTC is detected)>>GO TO 8.
YES (Symptom remains)>>GO TO 6.
NO
>> INSPECTION END
INSPECTION AND ADJUSTMENT
DLK-19
< BASIC INSPECTION >
[WITH I-KEY, WITHOUT SUPER LOCK]
C
D
E
F
G
H
I
J
L
M
A
B
DLK
N
O
P
INSPECTION AND ADJUSTMENT
ADDITIONAL SERVICE WHEN REPLACING CONTROL UNIT
ADDITIONAL SERVICE WHEN REPLACING CONTROL UNIT : Description
INFOID:0000000001396460
Perform the system initialization when replacing Intelligent Key unit, replacing Intelligent Key or registering an
additional Intelligent Key.
ADDITIONAL SERVICE WHEN REPLACING CONTROL UNIT : Special Repair Re-
quirement
INFOID:0000000001396461
Refer to the CONSULT-III Operation Instruction-NATS.
DLK-20
< FUNCTION DIAGNOSIS >
[WITH I-KEY, WITHOUT SUPER LOCK]
DOOR LOCK FUNCTION
FUNCTION DIAGNOSIS
DOOR LOCK FUNCTION
DOOR LOCK AND UNLOCK SWITCH
DOOR LOCK AND UNLOCK SWITCH : System Diagram
INFOID:0000000001396462
DOOR LOCK AND UNLOCK SWITCH OPERATION
DOOR LOCK AND UNLOCK SWITCH INDICATOR OPERATION
DOOR LOCK AND UNLOCK SWITCH : System Description
INFOID:0000000001396463
DOOR LOCK AND UNLOCK SWITCH OPERATION
Functions are available by operating the door lock and unlock switch on driver door. Interlocked with the lock/
unlock operation of door lock and unlock switch, door lock actuators of all doors are locked/unlocked.
Operation Condition
If the following conditions are not satisfied, door lock/unlock operation is not performed even if the door lock
and unlock switch is operated.
ALKIA0710GB
JMKIA0408GB
DOOR LOCK FUNCTION
DLK-21
< FUNCTION DIAGNOSIS >
[WITH I-KEY, WITHOUT SUPER LOCK]
C
D
E
F
G
H
I
J
L
M
A
B
DLK
N
O
P
NOTE:
When the door lock is locked with Intelligent Key or door request switch, door lock and unlock switch operation
will be invalid until either of the following conditions is satisfied.
• Turn ignition switch ON.
• Unlock with Intelligent Key or door request switch.
DOOR LOCK AND UNLOCK SWITCH INDICATOR OPERATION
Door lock and unlock switch indicator indicates door lock status. The indicator turns ON while ignition switch is
ON and each door lock is locked. If any door is opened, the indicator will turn OFF.
1 Minute Timer
A timer must be running to turn OFF the indicator. The timer will run for 1 minute after locking with Intelligent
Key, door request switch or auto door lock.
30 Minutes Timer
A timer must be running to turn OFF the indicator. The timer will run for 30 minutes after locking with door lock
and unlock switch.
NOTE:
1 minute timer condition is satisfied while the 30 minutes timer is active, however the 30 minutes timer does
not change to 1 minute timer condition.
Door lock and unlock switch
Operation condition
Lock operation
All of the following conditions are satisfied.
• Except driver side doors are closed.
• Doors are not locked with Intelligent Key or door request switch.
Unlock operation
All of the following conditions are satisfied.
• Doors are not locked with Intelligent Key or door request switch.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст