Nissan Tiida C11. Instruction — part 1410
TRANSAXLE ASSEMBLY
TM-691
< DISASSEMBLY AND ASSEMBLY >
[6MT: RS6F94R]
C
E
F
G
H
I
J
K
L
M
A
B
TM
N
O
P
18. Remove differential side oil seals (1) from clutch housing and
transaxle case using suitable tool.
CAUTION:
Do not damage clutch housing and transaxle case.
19. Remove differential side bearing outer race (1) from clutch hous-
ing using a brass bar.
CAUTION:
Do not damage clutch housing.
20. Remove differential side bearing outer race (1) and shim (2)
from transaxle case using a brass bar as shown.
CAUTION:
Do not damage transaxle case.
21. Remove retaining pin from selector lever (1) using suitable tool.
22. Remove selector lever.
23. Remove shift finger (1) from transaxle case.
PCIB1704E
PCIB1716E
PCIB1705E
JPDIC0106ZZ
PCIB1712E
TM-692
< DISASSEMBLY AND ASSEMBLY >
[6MT: RS6F94R]
TRANSAXLE ASSEMBLY
24. Remove selector lever oil seal and bushings from transaxle
case using suitable tool.
25. Remove oil gutter (1) from transaxle case.
26. Remove shifter lever oil seal (1) from transaxle case.
27. Remove bushings (1) from transaxle case using suitable tool.
28. Remove mainshaft rear bearing outer race from transaxle case
using suitable tool and then remove bearing preloading shim.
CAUTION:
Do not damage transaxle case.
PCIB1713E
PCIB1707E
PCIB1709E
PCIB1710E
PCIB1706E
TRANSAXLE ASSEMBLY
TM-693
< DISASSEMBLY AND ASSEMBLY >
[6MT: RS6F94R]
C
E
F
G
H
I
J
K
L
M
A
B
TM
N
O
P
29. Remove snap ring (1) and oil channel (2) from transaxle case.
30. Remove input shaft oil seal (1) from clutch housing using suit-
able tool.
31. Remove mainshaft front bearing outer race (1) and oil channel
(2) from clutch housing using Tool (A) and suitable tool (B).
32. Remove bushings (1) from clutch housing using suitable tool.
33. Remove two way connector (1) from clutch housing.
PCIB1708E
PCIB1714E
Tool number
A: KV381054S0 (
—
)
JPDIC0107ZZ
PCIB1717E
PCIB1720E
TM-694
< DISASSEMBLY AND ASSEMBLY >
[6MT: RS6F94R]
TRANSAXLE ASSEMBLY
34. Remove pinion gear (1) and pinion shaft (2) from clutch housing.
Assembly
INFOID:0000000001381647
1.
Install pinion gear (1) and pinion shaft (2) into clutch housing.
2.
Install two way connector (1) into clutch housing.
3.
Install bushings (1) until they are flush with end face of clutch
housing using suitable tool (A).
CAUTION:
Do not reuse bushings
PCIB1719E
PCIB1719E
PCIB1720E
JPDIC0108ZZ
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст