Nissan Sentra. Instruction — part 524
GW-18
< REMOVAL AND INSTALLATION >
FRONT REGULATOR
- Electric power supply to power window switch or motor is interrupted by blown fuse or disconnecting battery
cable, etc.
- Removal and installation of the regulator assembly.
- Removal and installation of the motor from the regulator assembly.
- Removal and installation of the harness connector of the power window switch.
- Operation of the regulator assembly as a unit.
- Removal and installation of the door glass.
- Removal and installation of the door glass run.
- Window is partly opened and or closed multiple times with out being fully closed.
• To perform system initialization, refer to
INSPECT THE FUNCTION OF THE ANTI-PINCH SYSTEM.
To inspect the anti-pinch system, refer to
FRONT POWER WINDOW MOTOR
GW-19
< REMOVAL AND INSTALLATION >
C
D
E
F
G
H
I
J
L
M
A
B
GW
N
O
P
FRONT POWER WINDOW MOTOR
Removal and Installation
INFOID:0000000009758191
REMOVAL
1. Remove the front door glass regulator (2). Refer to
2. Remove the bolts (A) and the front power window motor (1).
INSTALLATION
Installation is in the reverse order of removal.
ALKIA2638ZZ
GW-20
< REMOVAL AND INSTALLATION >
REAR DOOR GLASS
REAR DOOR GLASS
Removal and Installation
INFOID:0000000009758192
REMOVAL
NOTE:
LH rear door panel shown; RH similar.
1. Remove the rear door finisher. Refer to
INT-19, "Removal and Installation"
.
2. Remove the vapor barrier.
CAUTION:
Use care to not damage or tear vapor barrier during removal.
3. Remove the rear door window run rubber.
4. Remove bolts (A) and rear door glass rear run channel (1).
5. Temporarily reconnect the rear power window switch to raise/
lower the rear door glass until the rear door regulator to glass
bolts (A) can be seen through the access holes.
6. Remove the rear door glass to regulator bolts (A).
7. Remove the rear door glass.
INSTALLATION
Installation is in the reverse order of removal.
• After installation inspect and adjust as necessary.
REAR DOOR GLASS INSPECTION AFTER INSTALLATION
• Check that the door glass is securely set into the glass run groove.
• Lower the glass slightly [approx. 10 to 20 mm (0.4 to 0.8 in)], and make sure the clearance to the sash is par-
allel. If the clearance between the glass and sash is not parallel, loosen the regulator mounting bolts, guide
rail mounting bolts, and glass and carrier plate mounting bolts to correct the glass position.
ALKIA2636ZZ
ALKIA2635ZZ
REAR REGULATOR
GW-21
< REMOVAL AND INSTALLATION >
C
D
E
F
G
H
I
J
L
M
A
B
GW
N
O
P
REAR REGULATOR
Exploded View
INFOID:0000000009758193
Removal and Installation
INFOID:0000000009758194
NOTE:
RH rear door panel shown; LH side similar
REMOVAL
1. Remove the rear door finisher. Refer to
INT-19, "Removal and Installation"
.
2. Remove the vapor barrier.
CAUTION:
Use care to not damage or tear vapor barrier during removal.
3. Partially remove the rear door window run rubber.
1.
Rear door panel
2.
Rear door glass regulator motor 3.
Rear door glass regulator
4.
Rear door glass
5.
Rear door glass rubber run
ALKIA2813ZZ
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст