Nissan Sentra. Instruction — part 905
TM-256
< REMOVAL AND INSTALLATION >
[CVT: RE0F11A]
CONTROL CABLE
CONTROL CABLE
Exploded View
INFOID:0000000009759502
Removal and Installation
INFOID:0000000009759503
INSTALLATION
CAUTION:
Always apply the parking brake before performing removal and installation.
1. Apply the parking brake.
CAUTION:
Make sure the vehicle cannot move with the parking brake applied.
2. Remove the center console assembly. Refer to
IP-17, "Removal and Installation"
3. Move the shift selector to “P” position.
4. Remove the control cable from the shift selector assembly with the following procedure.
a. Disconnect the tip (A) of control cable from the shift selector
assembly.
b. Remove socket (B) from shift selector assembly.
1.
Control cable
2.
Lock plate
3.
Transaxle assembly
4.
Bracket A
5.
Bracket B
6.
CVT shift selector assembly
A. Instruction lever
B. Grommet
JSDIA1873GB
JSDIA3655ZZ
CONTROL CABLE
TM-257
< REMOVAL AND INSTALLATION >
[CVT: RE0F11A]
C
E
F
G
H
I
J
K
L
M
A
B
TM
N
O
P
5. Disengage the pawls (B) of the grommet (A), and pull down-
wards to remove.
6. Remove the battery. Refer to
PG-50, "Removal and Installation
7. Remove the control cable installation nut (A) from the instruction
lever (B).
8. Remove the lock plate (1).
9. Remove the tunnel stay (1).
10. Remove the exhaust front tube and sub muffler from the exhaust system. Refer to
.
JSDIA1809ZZ
JSDIA1875ZZ
JSDIA1812ZZ
: Front
JSDIA3657ZZ
TM-258
< REMOVAL AND INSTALLATION >
[CVT: RE0F11A]
CONTROL CABLE
11. Remove the heat plate fixtures (A).
12. Remove the control cable (1) from the bracket (2).
13. Remove the control cable from the vehicle.
INSTALLATION
Installation is in the reverse order of removal.
• From below the vehicle, press the grommet (A) into place until the
pawls (B) make a click sound.
CAUTION:
• Place the grommet on the floor, then fasten it in place from
below the vehicle.
• Check that pulling down on the grommet does not discon-
nect it.
• Pay attention to the following when connecting the control cable to the shift selector.
1. When connecting the control cable (1) to the shift selector
assembly (2), face the grooved surface of the rib (A) up and
insert the control cable until it stops.
: Front
JSDIA3658ZZ
: Front
JSDIA3660ZZ
JSDIA1809ZZ
JSDIA1624ZZ
CONTROL CABLE
TM-259
< REMOVAL AND INSTALLATION >
[CVT: RE0F11A]
C
E
F
G
H
I
J
K
L
M
A
B
TM
N
O
P
2. Install the socket (A) onto the shift selector.
CAUTION:
• Place the socket onto the shift selector, then fasten it in
place from above.
• Check that the pulling on the socket does not disconnect
it.
Inspection and Adjustment
INFOID:0000000009759504
INSPECTION AND ADJUSTMENT
Check the CVT position. If a malfunction is found, adjust the CVT position. Refer to
(Inspection) or
(Adjustment).
JSDIA1810ZZ
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст