Nissan Sentra. Instruction — part 269
DLK-192
< REMOVAL AND INSTALLATION >
[WITH INTELLIGENT KEY SYSTEM]
FUEL FILLER LID OPENER
5. Remove rear seat bolster (LH). Refer to
SE-24, "Removal and Installation - Rear Seat Bolster"
.
6. Remove trunk side finisher (LH). Refer to
INT-43, "TRUNK SIDE FINISHER : Removal and Installation"
.
7. Remove fuel filler lid opener cable (1) from fuel filler lid lock assembly. Refer to
LID LOCK : Removal and Installation"
8. Remove each cable protector (A), then remove fuel filler lid opener cable (1).
INSTALLATION
Installation is in the reverse order of removal.
CAUTION:
After installation, check fuel filler lid assembly open/close, lock/unlock operation.
FUEL FILLER LID LOCK
FUEL FILLER LID LOCK : Removal and Installation
INFOID:0000000009756505
REMOVAL
1. Fully open fuel filler lid.
Front
ALKIA2931ZZ
FUEL FILLER LID OPENER
DLK-193
< REMOVAL AND INSTALLATION >
[WITH INTELLIGENT KEY SYSTEM]
C
D
E
F
G
H
I
J
L
M
A
B
DLK
N
O
P
2. Insert a suitable tool (A) as shown into bottom of fuel filler lock
assembly(1).
3. Release upper and lower pawls (A) using a suitable tool and
remove fuel filler lid lock assembly (1).
CAUTION:
Be careful not to damage gasket (2) when removing.
4. Disconnect fuel filler lid opener cable (1) by pulling downward
and then sliding cable end to the side to remove from fuel filler
lid lock assembly (2).
INSTALLATION
Installation is in the reverse order of removal.
CAUTION:
After installation, check fuel filler lid assembly open/close, lock/unlock operation.
ALKIA2731ZZ
JMKIA8138ZZ
JMKIA8139ZZ
DLK-194
< REMOVAL AND INSTALLATION >
[WITH INTELLIGENT KEY SYSTEM]
DOOR SWITCH
DOOR SWITCH
Removal and Installation
INFOID:0000000009756507
REMOVAL
1. Remove the door switch screw (A).
2. Disconnect the harness connector from the door switch (1) and
remove.
INSTALLATION
Installation is in the reverse order of removal.
ALKIA2930ZZ
INSIDE KEY ANTENNA
DLK-195
< REMOVAL AND INSTALLATION >
[WITH INTELLIGENT KEY SYSTEM]
C
D
E
F
G
H
I
J
L
M
A
B
DLK
N
O
P
INSIDE KEY ANTENNA
CONSOLE
CONSOLE : Removal and Installation
INFOID:0000000009756508
REMOVAL
1. Remove the shift selector finisher. Refer to
.
2. Remove the inside key antenna (console) screws (A) and inside
key antenna (console) (1).
INSTALLATION
Installation is in the reverse order of removal.
LUGGAGE ROOM
LUGGAGE ROOM : Removal and Installation
INFOID:0000000009756509
REMOVAL
1. Disconnect the harness connector (A) from the inside key
antenna (luggage room) (1).
2. Remove the inside key antenna (luggage room) clips (B), and
remove.
INSTALLATION
Installation is in the reverse order of removal.
ALKIA3455ZZ
ALKIA2721ZZ
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст